SI4431-A0-FM Silicon Laboratories Inc, SI4431-A0-FM Datasheet - Page 42

• Manufacturer Part Number: SI4431-A0-FM
• Description: IC TXRX ISM 930MHZ 3.6V 20-QFN
• Manufacturer: Silicon Laboratories Inc

Specifications of SI4431-A0-FM

• Package / Case: 20-QFN
• Mfg Application Notes: Transitioning SI4430/31 to Rev B
• Frequency: 240MHz ~ 930MHz
• Data Rate - Maximum: 128kbps
• Modulation Or Protocol: FSK, GFSK, OOK
• Power - Output: 13dBm
• Sensitivity: -118dBm
• Voltage - Supply: 1.8 V ~ 3.6 V
• Current - Receiving: 18.5mA
• Current - Transmitting: 28mA
• Data Interface: PCB, Surface Mount
• Antenna Connector: PCB, Surface Mount
• Operating Temperature: -40°C ~ 85°C
• Number Of Receivers: 2
• Number Of Transmitters: 1
• Wireless Frequency: 240 MHz to 930 MHz
• Output Power: 13 dBm
• Operating Supply Voltage: 1.8 V to 3.6 V
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Maximum Supply Current: 28 mA
• Minimum Operating Temperature: - 40 C
• Modulation: FSK, GFSK, OOK
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Applications: -
• Memory Size: -
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: 336-1633-5

Si4431
6. Data Handling and Packet Handler
6.1. RX and TX FIFOs
Two 64 byte FIFOs are integrated into the chip, one for RX and one for TX, as shown in Figure 16. "Register 7Fh.
FIFO Access" is used to access both FIFOs. A burst write, as described in "3.1. Serial Peripheral Interface (SPI)"
on page 19, to address 7Fh will write data to the TX FIFO. A burst read from address 7Fh will read data from the
RX FIFO.
TX FIFO
RX FIFO
RX FIFO Almost Full
TX FIFO Almost Full
Threshold
Threshold
TX FIFO Almost Empty
Threshold
Figure 16. FIFO Thresholds
The TX FIFO has two programmable thresholds. An interrupt event occurs when the data in the TX FIFO reaches
these thresholds. The first threshold is the FIFO Almost Full threshold, txafthr[5:0]. The value in this register
corresponds to the desired threshold value in number of bytes. When the data being filled into the TX FIFO
reaches this threshold limit, an interrupt to the microcontroller is generated so the chip can enter TX mode to
transmit the contents of the TX FIFO. The second threshold for TX is the FIFO Almost Empty Threshold,
txaethr[5:0]. When the data being shifted out of the TX FIFO reaches the Almost Empty threshold an interrupt will
be generated. The microcontroller will need to switch out of TX mode or fill more data into the TX FIFO. The
Transceiver may be configured so that when the TX FIFO is empty the chip will automatically move to the Ready
state. In this mode the TX FIFO Almost Empty Threshold may not be useful. This functionality is set by the ffidle bit
in “Register 08h. Operating Mode and Function Control 2,” on page 92.
42
Preliminary Rev. 0.4