HD6433682 ETC, HD6433682 Datasheet - Page 119

• Manufacturer Part Number: HD6433682
• Description: Renesas 16-Bit Single-Chip Microcomputer H8 Family/H8/300H Tiny Series
• Manufacturer: ETC

7.2
The flash memory has the following registers.
7.2.1
FLMCR1 is a register that makes the flash memory change to program mode, program-verify
mode, erase mode, or erase-verify mode. For details on register setting, refer to section 7.4, Flash
Memory Programming/Erasing.
Bit
7
6
5
4
3
Flash memory control register 1 (FLMCR1)
Flash memory control register 2 (FLMCR2)
Erase block register 1 (EBR1)
Flash memory power control register (FLPWCR)
Flash memory enable register (FENR)
Bit Name
SWE
ESU
PSU
EV
Register Descriptions
Flash Memory Control Register 1 (FLMCR1)
Initial
Value
0
0
0
0
0
R/W
R/W
R/W
R/W
R/W
Description
Reserved
This bit is always read as 0.
Software Write Enable
When this bit is set to 1, flash memory
programming/erasing is enabled. When this bit is cleared
to 0, other FLMCR1 register bits and all EBR1 bits cannot
be set.
Erase Setup
When this bit is set to 1, the flash memory changes to the
erase setup state. When it is cleared to 0, the erase
setup state is cancelled. Set this bit to 1 before setting the
E bit to 1 in FLMCR1.
Program Setup
When this bit is set to 1, the flash memory changes to the
program setup state. When it is cleared to 0, the program
setup state is cancelled. Set this bit to 1 before setting
the P bit in FLMCR1.
Erase-Verify
When this bit is set to 1, the flash memory changes to
erase-verify mode. When it is cleared to 0, erase-verify
mode is cancelled.
Rev.3.00, 05/03, page 89 of 472