HD6433682 ETC, HD6433682 Datasheet - Page 357

• Manufacturer Part Number: HD6433682
• Description: Renesas 16-Bit Single-Chip Microcomputer H8 Family/H8/300H Tiny Series
• Manufacturer: ETC

18.6
18.6.1
This LSI's analog input is designed such that conversion accuracy is guaranteed for an input signal
for which the signal source impedance is 5 k or less. This specification is provided to enable the
A/D converter's sample-and-hold circuit input capacitance to be charged within the sampling time;
if the sensor output impedance exceeds 5 k , charging may be insufficient and it may not be
possible to guarantee A/D conversion accuracy. However, for A/D conversion in single mode with
a large capacitance provided externally, the input load will essentially comprise only the internal
input resistance of 10 k , and the signal source impedance is ignored. However, as a low-pass
filter effect is obtained in this case, it may not be possible to follow an analog signal with a large
differential coefficient (e.g., 5 mV/ s or greater) (see figure 18.6). When converting a high-speed
analog signal or converting in scan mode, a low-impedance buffer should be inserted.
18.6.2
Adding capacitance results in coupling with GND, and therefore noise in GND may adversely
affect absolute accuracy. Be sure to make the connection to an electrically stable GND.
Care is also required to ensure that filter circuits do not interfere with digital signals or act as
antennas on the mounting board.
Usage Notes
Permissible Signal Source Impedance
Influences on Absolute Accuracy
Figure 18.5 A/D Conversion Accuracy Definitions (2)
Digital output
Ideal A/D conversion
characteristic
Offset error
Actual A/D conversion
characteristic
Nonlinearity
error
Full-scale error
Analog
input voltage
FS
Rev. 3.00, 05/03, page 327 of 472