S912XET256J2VAGR Freescale Semiconductor, S912XET256J2VAGR Datasheet - Page 1114

• Manufacturer Part Number: S912XET256J2VAGR
• Description: 16-bit Microcontrollers - MCU Watchdog OSC/Timer -40 C to + 105 C HCS12X MCU SPI
• Manufacturer: Freescale Semiconductor

Specifications of S912XET256J2VAGR

• Core: HCS12X
• Data Bus Width: 16 bit
• Maximum Clock Frequency: 50 MHz
• Program Memory Size: 256 KB
• Data Ram Size: 16 KB
• On-chip Adc: Yes
• Package / Case: LQFP
• Mounting Style: SMD/SMT
• A/d Bit Size: 12 bit
• A/d Channels Available: 24
• Interface Type: CAN, SCI, SPI
• Maximum Operating Temperature: + 105 C
• Minimum Operating Temperature: - 40 C
• Number Of Programmable I/os: 119
• Number Of Timers: 25
• Program Memory Type: Flash
• Supply Voltage - Max: 1.98 V, 2.9 V, 5.5 V
• Supply Voltage - Min: 1.72 V, 2.7 V, 3.13 V

Chapter 28 768 KByte Flash Module (S12XFTM768K4V2)
28.4.2.1
The Erase Verify All Blocks command will verify that all P-Flash and D-Flash blocks have been erased.
Upon clearing CCIF to launch the Erase Verify All Blocks command, the Memory Controller will verify
that the entire Flash memory space is erased. The CCIF flag will set after the Erase Verify All Blocks
operation has completed.
28.4.2.2
The Erase Verify Block command allows the user to verify that an entire P-Flash or D-Flash block has been
erased. The FCCOB upper global address bits determine which block must be verified.
Upon clearing CCIF to launch the Erase Verify Block command, the Memory Controller will verify that
the selected P-Flash or D-Flash block is erased. The CCIF flag will set after the Erase Verify Block
operation has completed.
1114
1. As found in the memory map for FTM1024K5.
FERSTAT
Register
FSTAT
Erase Verify All Blocks Command
Erase Verify Block Command
A Flash word or phrase must be in the erased state before being
programmed. Cumulative programming of bits within a Flash word or
phrase is not allowed.
Table 28-33. Erase Verify All Blocks Command FCCOB Requirements
CCOBIX[2:0]
Table 28-35. Erase Verify Block Command FCCOB Requirements
CCOBIX[2:0]
MGSTAT1
MGSTAT0
EPVIOLIF
Table 28-34. Erase Verify All Blocks Command Error Handling
ACCERR
Error Bit
FPVIOL
000
000
MC9S12XE-Family Reference Manual Rev. 1.25
Set if CCOBIX[2:0] != 000 at command launch
Set if a Load Data Field command sequence is currently active
None
Set if any errors have been encountered during the read
Set if any non-correctable errors have been encountered during the read
None
0x01
0x02
CAUTION
FCCOB Parameters
FCCOB Parameters
Global address [22:16] of the
Error Condition
Flash block to be verified
Not required
(1)
.
Freescale Semiconductor
1