S912XET256J2VAGR Freescale Semiconductor, S912XET256J2VAGR Datasheet - Page 1130

• Manufacturer Part Number: S912XET256J2VAGR
• Description: 16-bit Microcontrollers - MCU Watchdog OSC/Timer -40 C to + 105 C HCS12X MCU SPI
• Manufacturer: Freescale Semiconductor

Specifications of S912XET256J2VAGR

• Core: HCS12X
• Data Bus Width: 16 bit
• Maximum Clock Frequency: 50 MHz
• Program Memory Size: 256 KB
• Data Ram Size: 16 KB
• On-chip Adc: Yes
• Package / Case: LQFP
• Mounting Style: SMD/SMT
• A/d Bit Size: 12 bit
• A/d Channels Available: 24
• Interface Type: CAN, SCI, SPI
• Maximum Operating Temperature: + 105 C
• Minimum Operating Temperature: - 40 C
• Number Of Programmable I/os: 119
• Number Of Timers: 25
• Program Memory Type: Flash
• Supply Voltage - Max: 1.98 V, 2.9 V, 5.5 V
• Supply Voltage - Min: 1.72 V, 2.7 V, 3.13 V

Chapter 28 768 KByte Flash Module (S12XFTM768K4V2)
28.4.2.18 Erase D-Flash Sector Command
The Erase D-Flash Sector operation will erase all addresses in a sector of the D-Flash user partition.
Upon clearing CCIF to launch the Erase D-Flash Sector command, the Memory Controller will erase the
selected Flash sector and verify that it is erased. The CCIF flag will set after the Erase D-Flash Sector
operation has completed.
1130
FERSTAT
Register
FSTAT
CCOBIX[2:0]
Table 28-69. Erase D-Flash Sector Command FCCOB Requirements
MGSTAT1
MGSTAT0
EPVIOLIF
ACCERR
Error Bit
000
001
FPVIOL
Table 28-68. Program D-Flash Command Error Handling
MC9S12XE-Family Reference Manual Rev. 1.25
Global address [15:0] anywhere within the sector to be erased.
Set if CCOBIX[2:0] < 010 at command launch
Set if CCOBIX[2:0] > 101 at command launch
Set if a Load Data Field command sequence is currently active
Set if command not available in current mode (see
Set if an invalid global address [22:0] is supplied
Set if a misaligned word address is supplied (global address [0] != 0)
Set if the global address [22:0] points to an area in the D-Flash EEE partition
Set if the requested group of words breaches the end of the D-Flash block or goes
into the D-Flash EEE partition
None
Set if any errors have been encountered during the verify operation
Set if any non-correctable errors have been encountered during the verify
operation
None
See
0x12
Section 28.1.2.2
FCCOB Parameters
for D-Flash sector size.
Global address [22:16] to identify
Error Condition
D-Flash block
Table
28-30)
Freescale Semiconductor