MC9S12P32CFT Freescale Semiconductor, MC9S12P32CFT Datasheet - Page 133

• Manufacturer Part Number: MC9S12P32CFT
• Description: MCU 16BIT 32K FLASH 48-QFN
• Manufacturer: Freescale Semiconductor
• Series: HCS12r

Specifications of MC9S12P32CFT

• Core Processor: HCS12
• Core Size: 16-Bit
• Speed: 32MHz
• Connectivity: CAN, SCI, SPI
• Peripherals: LVD, POR, PWM, WDT
• Number Of I /o: 34
• Program Memory Size: 32KB (32K x 8)
• Program Memory Type: FLASH
• Eeprom Size: 4K x 8
• Ram Size: 2K x 8
• Voltage - Supply (vcc/vdd): 1.72 V ~ 5.5 V
• Data Converters: A/D 10x12b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 48-QFN Exposed Pad
• Processor Series: S12P
• Core: HCS12
• 3rd Party Development Tools: EWHCS12
• Development Tools By Supplier: KIT33812ECUEVME, DEMO9S12PFAME
• Package: 48QFN EP
• Family Name: HCS12
• Maximum Speed: 32 MHz
• Operating Supply Voltage: 3.3|5 V
• Data Bus Width: 16 Bit
• Interface Type: CAN/SCI/SPI
• On-chip Adc: 10-chx12-bit
• Number Of Timers: 8
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

5.1.2.3
The BDM can be used until stop mode is entered. When CPU is in wait mode all BDM firmware
commands as well as the hardware BACKGROUND command cannot be used and are ignored. In this case
the CPU can not enter BDM active mode, and only hardware read and write commands are available. Also
the CPU can not enter a low power mode (stop or wait) during BDM active mode.
In stop mode the BDM clocks are stopped. When BDM clocks are disabled and stop mode is exited, the
BDM clocks will restart and BDM will have a soft reset (clearing the instruction register, any command in
progress and disable the ACK function). The BDM is now ready to receive a new command.
5.1.3
A block diagram of the BDM is shown in
5.2
A single-wire interface pin called the background debug interface (BKGD) pin is used to communicate
with the BDM system. During reset, this pin is a mode select input which selects between normal and
special modes of operation. After reset, this pin becomes the dedicated serial interface pin for the
background debug mode.
(CPMUSYNR). The BDM clock frequency is always VCO clock frequency divided by 8. After reset the
BDM clock is based on the reset values of the CPMUSYNR register (4 MHz). When modifying the VCO
Freescale Semiconductor
System
Host
External Signal Description
Block Diagram
Low-Power Modes
Register Block
BKGD
BDMSTS
Register
BDMACT
ENBDM
UNSEC
TRACE
SDV
Interface
The communication rate of this pin is based on the settings for the VCO clock
Serial
S12P-Family Reference Manual, Rev. 1.13
Control
Data
Figure 5-1. BDM Block Diagram
Figure
Standard BDM Firmware
16-Bit Shift Register
Secured BDM Firmware
Instruction Code
LOOKUP TABLE
LOOKUP TABLE
5-1.
Execution
and
Background Debug Module (S12SBDMV1)
Bus Interface
Control Logic
and
Address
Data
Control
Clocks
133