HFIXF1110CC.B3-998844 Cortina Systems Inc, HFIXF1110CC.B3-998844 Datasheet - Page 52

• Manufacturer Part Number: HFIXF1110CC.B3-998844
• Description: IC ETHERNET MAC 10PORT 552-CBGA
• Manufacturer: Cortina Systems Inc

Specifications of HFIXF1110CC.B3-998844

• Controller Type: Ethernet Controller, MAC
• Interface: SPI-4.2
• Voltage - Supply: 1.8 V, 2.5 V
• Operating Temperature: 0°C ~ 70°C
• Mounting Type: Surface Mount
• Package / Case: 575-BCBGA Exposed Pad (552 Bumps)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Current - Supply: -
• Other names: 1008-1010

IXF1110 MAC
Datasheet
250210, Revision 11.0
13 April 2009
Table 16
5.1.8.2
Cortina Systems
etherStatsOctets
etherStatsPkts
etherStatsBroadcastPkts
etherStatsMulticastPkts
etherStatsCRCAlignErrors
etherStatsOversizePkts
etherStatsJabbers
etherStatsCollisions
etherStatsPkts64Octets
etherStatsPkts65to127Octets
etherStatsPkts128to255Octets
etherStatsPkts256to511Octets
etherStatsPkts512to1023Octets
etherStatsPkts1024to1518Octets
etherStatsOwner
etherStatsStatus
1. The RMON spec requires that this is, “The total number of events where packets were dropped by the probe due to a lack of
2. TheIXF1110 MAC has an extra counter RX/TXUCPkts that can be used.
3. The IXF1110 MAC has an extra counter RX/TXPktstoMaxOctets that can be used in addition to the RMON stats. This is
RMON Ethernet Statistics
resources. Note that this number is not necessarily the number of packets dropped; it is the number of times this condition
has been detected.” The RX/TX FIFO Number of Frames Removed Register in the IXF1110 MAC supports this and will
increment when either an RX or TX FIFO has over flowed. If any IXF1110 MAC programmable packet filtering is enabled, the
RX/TX Number of Frames Removed Register increments with every frame removed in addition to the existing frames
counted due to FIFO overflow.
required to accommodate the Jumbo packet frames requirement.
Group 1 Statistics
RMON Additional Statistics Registers (Sheet 2 of 2)
Conventions
The following conventions are used throughout the RMON MIB and its companion
documents.
®
IXF1110 10-Port 1000 Mbps Ethernet Media Access Controller
Counter32
Counter32
Counter32 RX/TXBCPkts
Counter32 RX/TXMCPkts
Counter32
Counter32
Counter32 RXJabberErrors
Counter32
Counter32 RX/TXPkts64Octets
Counter32 RX/TXPkts65to127Octets
Counter32 RX/TXPkts128to255Octets
Counter32 RX/TXPkts256to511Octets
Counter32 RX/TXPkts512to1023Octets
Counter32
Owner
String
Entry
Status
Type
RXOctetsTotalOK
RXOctetsBad
TXOctetsTotalOK
TXOctetsBad
RX/TXUCPkts
RX/TXBCPkts
RX/TXMCPkts
RXAlignErrors
RXFCSErrors
TXCRCError
RXLongErrors
TXExcessiveLengthDrop
TXSingleCollisions
TXMultipleCollisions
TXLateCollisions
TXTotalCollisions
RX/TXPkts1024to1518Octet
s
N/A
N/A
IXF1110 MAC Equivalent
Statistics
Counter32
Counter32
Counter32
Counter32
Counter32
Counter32
Counter32
Counter32
Counter32
Counter32
Counter32
Counter32
Counter32
Counter32
N/A
N/A
Type
Note: The IXF1110 MAC has two
counters for RX and TX that use
different naming conventions for
total Octets and Octets bad. These
counters need to be combined to
meet the RMON spec.
Note: The IXF1110 MAC has three
counters for etherStatsPkts that
need to be combined to give the
total packets as defined by the
RMON spec.
OK
See table note 2.
Note: The IXF1110 MAC has two
counters for alignment and CRC
errors for the RX side only.
The IXF1110 MAC has CRCError
for the TX side.
OK
OK
OK
Note: Registers exist on the TX
side but should not increment since
the IXF1110 MAC only supports
full-duplex.
OK
OK
OK
OK
OK
See table note 3.
N/A
N/A
IXF1110 MAC Documentation
Definition of RMON Versus
5.1 Media Access Controller
Page 52