MPC8533EVTARJ Freescale Semiconductor, MPC8533EVTARJ Datasheet - Page 329

• Manufacturer Part Number: MPC8533EVTARJ
• Description: MPU POWERQUICC 783-PBGA
• Manufacturer: Freescale Semiconductor

Specifications of MPC8533EVTARJ

• Processor Type: MPC85xx PowerQUICC III 32-Bit
• Speed: 1.067GHz
• Voltage: 1V
• Mounting Type: Surface Mount
• Package / Case: 783-FCPBGA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Features: -

Freescale Semiconductor
MBA[2:0]
MA[15:0]
Signal
MCAS
MRAS
Table 9-3. Memory Interface Signals—Detailed Signal Descriptions (continued)
MPC8533E PowerQUICC III Integrated Host Processor Family Reference Manual, Rev. 1
I/O
O
O
O
O
Address bus. Memory controller outputs for the address to the DRAM. MA[15:0] carry 16 of the address
bits for the DDR memory interface corresponding to the row and column address bits. MA0 is the lsb of
the address output from the memory controller.
Logical bank address. Outputs that drive the logical (or internal) bank address pins of the SDRAM. Each
SDRAM supports four or eight addressable logical sub-banks. Bit zero of the memory controller’s output
bank address must be connected to bit zero of the SDRAM’s input bank address. MBA0, the
least-significant bit of the three bank address signals, is asserted during the mode register set command
to specify the extended mode register.
Column address strobe. Active-low SDRAM address multiplexing signal. MCAS is asserted for read or
write transactions and for mode register set, refresh, and precharge commands.
Row address strobe. Active-low SDRAM address multiplexing signal. Asserted for activate commands.
In addition; used for mode register set commands and refresh commands.
Meaning
Meaning
Meaning
Meaning
Timing Assertion/Negation—The address is always driven when the memory controller is enabled.
Timing Assertion/Negation—Same timing as MA n
Timing Assertion/Negation—Assertion and negation timing is directed by the values described in
Timing Assertion/Negation—Assertion and negation timing is directed by the values described in
State
State
State
State
Asserted/Negated—Represents the address driven by the DDR memory controller. Contains
High impedance—When the memory controller is disabled
Asserted/Negated—Selects the DDR SDRAM logical (or internal) bank to be activated during
High impedance—Same timing as MA n
Asserted—Indicates that a valid SDRAM column address is on the address bus for read and
Negated—The column address is not guaranteed to be valid.
High impedance—MCAS is always driven unless the memory controller is disabled.
Asserted—Indicates that a valid SDRAM row address is on the address bus for read and
Negated—The row address is not guaranteed to be valid.
High impedance—MRAS is always driven unless the memory controller is disabled.
different portions of the address depending on the memory size and the DRAM
command being issued by the memory controller. See
complete description of the mapping of these signals.
It is valid when a transaction is driven to DRAM (when MCS n is active).
the row address phase and selects the SDRAM internal bank for the read or write
operation during the column address phase of the memory access.
Table 9-41Table 9-42
write transactions. See
for various other SDRAM commands.
Section 9.4.1.4, “DDR SDRAM Timing Configuration 0 (TIMING_CFG_0),”
Section 9.4.1.5, “DDR SDRAM Timing Configuration 1 (TIMING_CFG_1),”
Section 9.4.1.6, “DDR SDRAM Timing Configuration 2
Section 9.4.1.3, “DDR SDRAM Timing Configuration 3 (TIMING_CFG_3).”
write transactions. See
for various other SDRAM commands.
Section 9.4.1.4, “DDR SDRAM Timing Configuration 0 (TIMING_CFG_0),”
Section 9.4.1.5, “DDR SDRAM Timing Configuration 1 (TIMING_CFG_1),”
Section 9.4.1.6, “DDR SDRAM Timing Configuration 2
Section 9.4.1.3, “DDR SDRAM Timing Configuration 3 (TIMING_CFG_3).”
describes the mapping of these signals in all cases.
Table 9-46
Table 9-46
Description
for more information on the states required on MCAS
for more information on the states required on MRAS
Table 9-41Table 9-42
(TIMING_CFG_2),” and
(TIMING_CFG_2),” and
DDR Memory Controller
for a
9-7