s3c4510b Samsung Semiconductor, Inc., s3c4510b Datasheet - Page 83

• Manufacturer Part Number: s3c4510b
• Description: 16/32-bit Risc Microcontroller
• Manufacturer: Samsung Semiconductor, Inc.

S3C4510B
ADDRESSING MODES
The transfer addresses are determined by the contents of the base register (Rn), the pre/post bit (P) and the up/
down bit (U). The registers are transferred in the order lowest to highest, so R15 (if in the list) will always be
transferred last. The lowest register also gets transferred to/from the lowest memory address. By way of
illustration, consider the transfer of R1, R5 and R7 in the case where Rn = 0x1000 and write back of the modified
base is required (W = 1). Figure 3.19-22 show the sequence of register transfers, the addresses used, and the
value of Rn after the instruction has completed.
In all cases, had write back of the modified base not been required (W = 0), Rn would have retained its initial
value of 0x1000 unless it was also in the transfer list of a load multiple register instruction, when it would have
been overwritten with the loaded value.
ADDRESS ALIGNMENT
The address should normally be a word aligned quantity and non-word aligned addresses do not affect the
instruction. However, the bottom 2 bits of the address will appear on A[1:0] and might be interpreted by the
memory system.
Rn
Figure 3-19. Post-Increment Addressing
R5
R1
1
3
0x100C
0x1000
0x0FF4
0x100C
0x1000
0x0FF4
Rn
R1
R7
R5
R1
2
4
0x100C
0x1000
0x0FF4
0x100C
0x1000
0x0FF4
INSTRUCTION SET
3-41