DF2218BR24V Renesas Electronics America, DF2218BR24V Datasheet - Page 169

• Manufacturer Part Number: DF2218BR24V
• Description: IC H8S/2218 MCU FLASH 112-LFBGA
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2200r

Specifications of DF2218BR24V

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 24MHz
• Connectivity: SCI, SmartCard, USB
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 69
• Program Memory Size: 128KB (128K x 8)
• Program Memory Type: FLASH
• Ram Size: 12K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 3.6 V
• Data Converters: A/D 6x10b
• Oscillator Type: External
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 112-LFBGA
• For Use With: HS0005KCU11H - EMULATOR E10A-USB H8S(X),SH2(A)3DK2218-SS - KIT DEV H8S/2218 WINDOWS SIDESHW3DK2218 - DEV EVAL KIT H8S/2218
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

5.7.2
Instructions that disable interrupts are LDC, ANDC, ORC, and XORC. After any of these
instructions is executed, all interrupts including NMI are disabled and the next instruction is
always executed. When the I bit is set by one of these instructions, the new value becomes valid
two states after execution of the instruction ends.
5.7.3
There are times when interrupt acceptance is disabled by the interrupt controller.
The interrupt controller disables interrupt acceptance for a 3-state period after the CPU has
updated the mask level with an LDC, ANDC, ORC, or XORC instruction.
5.7.4
Interrupt operation differs between the EEPMOV.B instruction and the EEPMOV.W instruction.
With the EEPMOV.B instruction, an interrupt request (including NMI) issued during the transfer
is not accepted until the move is completed.
With the EEPMOV.W instruction, if an interrupt request is issued during the transfer, interrupt
exception handling starts at a break in the transfer cycle. The PC value saved on the stack in this
case is the address of the next instruction.
Therefore, if an interrupt is generated during execution of an EEPMOV.W instruction, the
following coding should be used.
5.7.5
When operating by clock input, acceptance of input to an IRQ is synchronized with the clock. In
software standby mode and watch mode, the input is accepted asynchronously. For details on the
input conditions, see section 22.4.2, Control Signal Timing.
L1: EEPMOV.W
MOV.W
BNE
Instructions that Disable Interrupts
Times when Interrupts Are Disabled
Interrupts during Execution of EEPMOV Instruction
IRQ Interrupt
L1
R4, R4
Rev.7.00 Dec. 24, 2008 Page 113 of 698
REJ09B0074-0700