HD6412240 RENESAS [Renesas Technology Corp], HD6412240 Datasheet - Page 527

• Manufacturer Part Number: HD6412240
• Description: Renesas 16-Bit Single-Chip Microcomputer H8S Family / H8S/2200 Series
• Manufacturer: RENESAS [Renesas Technology Corp]

The operation sequence is as follows.
[1] When the data line is not in use it is in the high-impedance state, and is fixed high with a pull-
[2] The transmitting station starts transfer of one frame of data. The data frame starts with a start
[3] With the Smart Card interface, the data line then returns to the high-impedance state. The data
[4] The receiving station carries out a parity check.
[5] If the transmitting station does not receive an error signal, it proceeds to transmit the next data
13.3.4
Table 13.3 shows a bit map of the registers used by the smart card interface.
Bits indicated as 0 or 1 must be set to the value shown. The setting of other bits is described
below.
up resistor.
bit (Ds, low-level), followed by 8 data bits (D0 to D7) and a parity bit (Dp).
line is pulled high with a pull-up resistor.
If there is no parity error and the data is received normally, the receiving station waits for
reception of the next data.
If a parity error occurs, however, the receiving station outputs an error signal (DE, low-level)
to request retransmission of the data. After outputting the error signal for the prescribed length
of time, the receiving station places the signal line in the high-impedance state again. The
signal line is pulled high again by a pull-up resistor.
frame.
If it does receive an error signal, however, it returns to step [2] and retransmits the erroneous
data.
Register Settings
Rev.3.00 Mar. 26, 2007 Page 485 of 772
Section 13 Smart Card Interface
REJ09B0355-0300