S912XET512J3VALR Freescale Semiconductor, S912XET512J3VALR Datasheet - Page 1058

• Manufacturer Part Number: S912XET512J3VALR
• Description: 16-bit Microcontrollers - MCU 16 BIT,512K FLASH
• Manufacturer: Freescale Semiconductor

Specifications of S912XET512J3VALR

• Rohs: yes
• Core: HCS12X
• Processor Series: MC9S12XE
• Data Bus Width: 16 bit
• Maximum Clock Frequency: 50 MHz
• Program Memory Size: 512 KB
• Data Ram Size: 32 KB
• On-chip Adc: Yes
• Operating Supply Voltage: 3.13 V to 5.5 V
• Operating Temperature Range: - 40 C to + 105 C
• Package / Case: LQFP-112
• Mounting Style: SMD/SMT

Chapter 27 512 KByte Flash Module (S12XFTM512K3V1)
Upon clearing CCIF to launch the Erase All Blocks command, the Memory Controller will erase the entire
Flash memory space and verify that it is erased. If the Memory Controller verifies that the entire Flash
memory space was properly erased, security will be released. During the execution of this command
(CCIF=0) the user must not write to any Flash module register. The CCIF flag will set after the Erase All
Blocks operation has completed.
27.4.2.9
The Erase P-Flash Block operation will erase all addresses in a P-Flash block.
Upon clearing CCIF to launch the Erase P-Flash Block command, the Memory Controller will erase the
selected P-Flash block and verify that it is erased. The CCIF flag will set after the Erase P-Flash Block
operation has completed.
1058
FERSTAT
Register
FSTAT
Erase P-Flash Block Command
Table 27-49. Erase P-Flash Block Command FCCOB Requirements
CCOBIX[2:0]
CCOBIX[2:0]
Table 27-47. Erase All Blocks Command FCCOB Requirements
MGSTAT1
MGSTAT0
EPVIOLIF
ACCERR
Error Bit
FPVIOL
000
000
001
Table 27-48. Erase All Blocks Command Error Handling
MC9S12XE-Family Reference Manual Rev. 1.25
Set if CCOBIX[2:0] != 000 at command launch
Set if a Load Data Field command sequence is currently active
Set if command not available in current mode (see
Set if any area of the P-Flash memory is protected
Set if any errors have been encountered during the verify operation
Set if any non-correctable errors have been encountered during the verify
operation
Set if any area of the buffer RAM EEE partition is protected
Global address [15:0] in P-Flash block to be erased
0x08
0x09
FCCOB Parameters
FCCOB Parameters
Error Condition
Global address [22:16] to
identify P-Flash block
Not required
Table
27-30)
Freescale Semiconductor