S912XET512J3VALR Freescale Semiconductor, S912XET512J3VALR Datasheet - Page 1129

• Manufacturer Part Number: S912XET512J3VALR
• Description: 16-bit Microcontrollers - MCU 16 BIT,512K FLASH
• Manufacturer: Freescale Semiconductor

Specifications of S912XET512J3VALR

• Rohs: yes
• Core: HCS12X
• Processor Series: MC9S12XE
• Data Bus Width: 16 bit
• Maximum Clock Frequency: 50 MHz
• Program Memory Size: 512 KB
• Data Ram Size: 32 KB
• On-chip Adc: Yes
• Operating Supply Voltage: 3.13 V to 5.5 V
• Operating Temperature Range: - 40 C to + 105 C
• Package / Case: LQFP-112
• Mounting Style: SMD/SMT

28.4.2.17 Program D-Flash Command
The Program D-Flash operation programs one to four previously erased words in the D-Flash user
partition. The Program D-Flash operation will confirm that the targeted location(s) were successfully
programmed upon completion.
Upon clearing CCIF to launch the Program D-Flash command, the user-supplied words will be transferred
to the Memory Controller and be programmed. The CCOBIX index value at Program D-Flash command
launch determines how many words will be programmed in the D-Flash block. No protection checks are
made in the Program D-Flash operation on the D-Flash block, only access error checks. The CCIF flag is
set when the operation has completed.
Freescale Semiconductor
FERSTAT
Register
FSTAT
A Flash word must be in the erased state before being programmed.
Cumulative programming of bits within a Flash word is not allowed.
Table 28-66. Erase Verify D-Flash Section Command Error Handling
CCOBIX[2:0]
Table 28-67. Program D-Flash Command FCCOB Requirements
MGSTAT1
MGSTAT0
EPVIOLIF
ACCERR
Error Bit
FPVIOL
000
001
010
011
100
101
MC9S12XE-Family Reference Manual Rev. 1.25
Set if CCOBIX[2:0] != 010 at command launch
Set if a Load Data Field command sequence is currently active
Set if command not available in current mode (see
Set if an invalid global address [22:0] is supplied
Set if a misaligned word address is supplied (global address [0] != 0)
Set if the global address [22:0] points to an area of the D-Flash EEE partition
Set if the requested section breaches the end of the D-Flash block or goes into
the D-Flash EEE partition
None
Set if any errors have been encountered during the read
Set if any non-correctable errors have been encountered during the read
None
Global address [15:0] of word to be programmed
0x11
Word 1 program value, if desired
Word 2 program value, if desired
Word 3 program value, if desired
CAUTION
Word 0 program value
FCCOB Parameters
Error Condition
Chapter 28 768 KByte Flash Module (S12XFTM768K4V2)
Global address [22:16] to
identify the D-Flash block
Table
28-30)
1129