S912XET512J3VALR Freescale Semiconductor, S912XET512J3VALR Datasheet - Page 1131

• Manufacturer Part Number: S912XET512J3VALR
• Description: 16-bit Microcontrollers - MCU 16 BIT,512K FLASH
• Manufacturer: Freescale Semiconductor

Specifications of S912XET512J3VALR

• Rohs: yes
• Core: HCS12X
• Processor Series: MC9S12XE
• Data Bus Width: 16 bit
• Maximum Clock Frequency: 50 MHz
• Program Memory Size: 512 KB
• Data Ram Size: 32 KB
• On-chip Adc: Yes
• Operating Supply Voltage: 3.13 V to 5.5 V
• Operating Temperature Range: - 40 C to + 105 C
• Package / Case: LQFP-112
• Mounting Style: SMD/SMT

28.4.2.19 Enable EEPROM Emulation Command
The Enable EEPROM Emulation command causes the Memory Controller to enable EEE activity. EEE
activity is disabled after any reset.
Upon clearing CCIF to launch the Enable EEPROM Emulation command, the CCIF flag will set after the
Memory Controller enables EEE operations using the contents of the EEE tag RAM and tag counter. The
Full Partition D-Flash or the Partition D-Flash command must be run prior to launching the Enable
EEPROM Emulation command.
Freescale Semiconductor
FERSTAT
FERSTAT
Register
Register
FSTAT
FSTAT
Table 28-71. Enable EEPROM Emulation Command FCCOB Requirements
Table 28-72. Enable EEPROM Emulation Command Error Handling
CCOBIX[2:0]
MGSTAT1
MGSTAT0
EPVIOLIF
MGSTAT1
MGSTAT0
EPVIOLIF
ACCERR
ACCERR
Error Bit
Error Bit
Table 28-70. Erase D-Flash Sector Command Error Handling
FPVIOL
FPVIOL
000
MC9S12XE-Family Reference Manual Rev. 1.25
Set if CCOBIX[2:0] != 001 at command launch
Set if a Load Data Field command sequence is currently active
Set if command not available in current mode (see
Set if an invalid global address [22:0] is supplied
Set if a misaligned word address is supplied (global address [0] != 0)
Set if the global address [22:0] points to the D-Flash EEE partition
None
Set if any errors have been encountered during the verify operation
Set if any non-correctable errors have been encountered during the verify
operation
None
Set if CCOBIX[2:0] != 000 at command launch
Set if a Load Data Field command sequence is currently active
Set if Full Partition D-Flash or Partition D-Flash command not previously run
None
None
None
None
0x13
FCCOB Parameters
Error Condition
Error Condition
Chapter 28 768 KByte Flash Module (S12XFTM768K4V2)
Not required
Table
28-30)
1131