MT29F128G08WAAC6 Micron, MT29F128G08WAAC6 Datasheet - Page 8

• Manufacturer Part Number: MT29F128G08WAAC6
• Description: NAND Flash Memory
• Manufacturer: Micron

General Description
PDF: 09005aef8278ee3f / Source: 09005aef81f17540
16gb_nand_mlc_l52a__2.fm -Rev. D 5/08 EN
NAND Flash technology provides a cost-effective solution for applications requiring
high-density, solid-state storage. The MT29F16G is a 16Gb NAND Flash memory device.
The MT29F32G is a two-die stack that operates as two independent 16Gb devices. The
MT29F64G is a four-die stack that operates as two independent 32Gb devices, providing
a total storage capacity of 64Gb in a single, space-saving package. MT29F128G is a eight-
die stack that operates as four independent 32Gb devices, providing a total storage
capacity of 128Gb in a single, space-saving package. Micron® NAND Flash devices
include standard NAND Flash features as well as new features designed to enhance sys-
tem-level performance.
Micron NAND Flash devices use a highly multiplexed 8-bit bus (I/O[7:0]) to transfer
data, addresses, and instructions. The five command pins (CLE, ALE, CE#, RE#, WE#)
implement the NAND Flash command bus interface protocol. Two additional pins con-
trol hardware write protection (WP#) and monitor device status (R/B#).
This hardware interface creates a low-pin-count device with a standard pinout that is
the same from one density to another, allowing future upgrades to higher densities with-
out board redesign.
The MT29F16G, MT29F32G, MT29F64G, and MT29F128G devices contain two planes
per die, for a total of two or four planes per CE#. Each plane consists of 2,048 blocks.
Each block is subdivided into 128 programmable pages. Each page consists of 4,314
bytes. The pages are further divided into a 4,096-byte data storage region with a separate
218-byte area. The 218-byte area is typically used for error management functions.
The contents of each page can be programmed in
erased in
maximize cycle endurance. PROGRAM/ERASE endurance is specified at 10,000 cycles
when using appropriate error correction code (ECC) and error management.
The MT29F8G, MT29F16G, MT29F16G, MT29F32G, and MT9F64G are ONFI 1.0-compli-
ant devices. The ONFI 1.0 specification can be found at www.onfi.org.
t
BERS. On-chip control logic automates PROGRAM and ERASE operations to
Micron Confidential and Proprietary
8
www.DataSheet.net/
16, 32, 64, 128Gb NAND Flash Memory
Micron Technology, Inc., reserves the right to change products or specifications without notice.
t
PROG, and an entire block can be
General Description
©2005 Micron Technology, Inc. All rights reserved.
Datasheet pdf - http://www.DataSheet4U.co.kr/