MT29F128G08WAAC6 Micron, MT29F128G08WAAC6 Datasheet - Page 82

• Manufacturer Part Number: MT29F128G08WAAC6
• Description: NAND Flash Memory
• Manufacturer: Micron

RESET Operation
RESET FFh
PDF: 09005aef8278ee3f / Source: 09005aef81f17540
16gb_nand_mlc_l52a__2.fm -Rev. D 5/08 EN
The RESET (FFh) command is used to put the memory device into a known condition
and to abort a command sequence in progress.
READ, PROGRAM, and ERASE commands can be aborted while the device is in the busy
state. The contents of the memory location being programmed or the block being erased
are no longer valid. The data may be partially erased or programmed, and is invalid. The
command register is cleared and is ready for the next command. The data register and
cache register contents are invalid.
If a RESET (FFh) command is issued during any type of programming operation (PRO-
GRAM PAGE, PROGRAM PAGE CACHE MODE, PROGRAM for INTERNAL DATA MOVE,
TWO-PLANE PROGRAM PAGE, TWO-PLANE PROGRAM PAGE CACHE MODE, or TWO-
PLANE PROGRAM for INTERNAL DATA MOVE) while R/B# is LOW, the data in the
shared-memory cells being programmed could become invalid. Interrupting any pro-
gramming operation on one page could corrupt the data in another page within the
block being programmed.
The status register contains the value E0h when WP# is HIGH; otherwise it is written
with a 60h value. R/B# goes low for tRST after the RESET command is written to the
command register (see Figure 56 and Table 16 on page 83).
The RESET command must be issued to all CE#s as the first command after power-on.
The device will be busy for a maximum of 1ms. During and following the initial RESET
command, and prior to issuing the next command, use of the TWO PLANE/MULTIPLE-
DIE READ STATUS (78h) command is prohibited.
If the RESET command is issued during or following an interleaved-die operation then
the TWO-PLANE/MULTIPLE-DIE READ STATUS (78h) command must be issued, once
per die, to determine completion of the RESET operation. Use of the READ STATUS
(70h) command is not permitted until the 78h command is issued.
Micron Confidential and Proprietary
82
www.DataSheet.net/
16, 32, 64, 128Gb NAND Flash Memory
Micron Technology, Inc., reserves the right to change products or specifications without notice.
Command Definitions
©2005 Micron Technology, Inc. All rights reserved.
Datasheet pdf - http://www.DataSheet4U.co.kr/