FX1S-30MR-ES/UL MITSUBISHI, FX1S-30MR-ES/UL Datasheet - Page 165

• Manufacturer Part Number: FX1S-30MR-ES/UL
• Description: PLC, 16 IN, 14 RELAY OUT, 110V/2
• Manufacturer: MITSUBISHI

Specifications of FX1S-30MR-ES/UL

• No. Of Analogue Inputs: 16
• No. Of Analogue Outputs: 14
• Ip/nema Rating: IP10
• Approval Bodies: CE, CUL, UL
• External Depth: 49mm
• External Length / Height: 90mm
• External Width: 60mm
• Mounting Type: Panel

5.5.1
5.5.2
FX Series Programmable Controlers
ZRST (FNC 40)
The specified device range cannot contain mixed device types, i.e. C000 specified as the first
destination device (D
resetting counters, standard and high speed counters cannot be reset as part of the same
range.
If D
DECO (FNC 41)
ZRST
FNC 40
(
Reset)
DECO
FNC 41
(Decode)
Zone
Mnemonic
Mnemonic
1
is greater than (>) D
Used to reset a
range of like
devices in one
operation
Source data value
Q identifies the
Qth bit of the
destination device
which will be
turned ON
Function
Function
1
) cannot be paired with T199 as the second destination device (D
2
then only device D
Y, M,S,
T, C, D
Note:
D
Standard and High speed counters cannot be mixed.
K, H,
X, Y, M,S,
T, C, D, V,
Z
1
must be less than or equal (
S
Operation :
Source data is provided by a combination of operands
S and n. Where S specifies the head address of the
data and n, the number of consecutive bits. The
source data is read as a single number (binary to
decimal conversion) Q. The source number Q is the
location of a bit within the destination device (D) which
will be turned ON (see example opposite). When the
destination device is a data device n must be within
the range 1 to 4 as there are only 16 available
destination bits in a single data word. All unused data
bits within the word are set to 0.
Operation :
The range of devices, inclusive of those specified as
the two destinations are reset, i.e. for data devices the
current value is set to 0 (zero) and for bit elements,
the devices are turned OFF, i.e. also set to 0 (zero).
S
Y, M, S,
T, C, D
1
is reset.
D
Operands
Operands
K, H,
Note:
D= Y,M,S then n range =
1-8
D= T,C,D then
n range = 1-4
n= 0, then no
processing
) to D
2.
D
n
Applied Instructions 5
ZRST,
ZRSTP:
5 steps
DECO,
DECOP:
7 steps
Program steps
Program steps
5-43
2
). When