FX1S-30MR-ES/UL MITSUBISHI, FX1S-30MR-ES/UL Datasheet - Page 251

• Manufacturer Part Number: FX1S-30MR-ES/UL
• Description: PLC, 16 IN, 14 RELAY OUT, 110V/2
• Manufacturer: MITSUBISHI

Specifications of FX1S-30MR-ES/UL

• No. Of Analogue Inputs: 16
• No. Of Analogue Outputs: 14
• Ip/nema Rating: IP10
• Approval Bodies: CE, CUL, UL
• External Depth: 49mm
• External Length / Height: 90mm
• External Width: 60mm
• Mounting Type: Panel

5.13.3
FX Series Programmable Controlers
PLSV(FNC157)
Points to note:
a)Users may use ouput pulse frequencies [S
100kHz.
b)Only Y000 or Y001 can be used for the pulse output [D
Because of the nature of the high speed output, transistor type output units should be used
with this instruction. Relay type outputs will suffer a greatly reduced life, and will cause faulse
outputs to occur.
To ensure a ‘clean’ output signal when using transistor type units, the load current should be
200mA or higher. It may be necessary to use ‘pull up’ resistors.
c)Rotation direction signal output [D2} operated as follows: if [D
[D
d)The pulse frequensy [S] can be changed even when pulses are being output.
e)Acceleration/deceleration are not performed at start/stop. If cushion start/stop is required,
increase or decrease the output pulse frequency [S] using the FNC67 RAMP instruction.
f)If the instruction drive contact turns off while pulses are output, the machine stopps without
deceleration
g)Once the instruction drive contact is off, re-drive of the instruction is not possible while the
pulse output flag (Y000 : [M8147] Y001 : [M8148]) is ON.
h)The normal or reverse direction is specified by the positive or negative sign of the output
pulse frequency [S]
i)Related device numbers.
• Attention should be paid to the instruction drive timing.
PLSV
FNC 157
Pulse V
2
Mnemonic
] = ON, rotation = positive.
D8141 (upper digit) & D8140 (lower digit) : Current value register of Y000 (32-bit)
D8143 (upper digit) & D8142 (lower digit) : Current value register of Y001 (32-bit)
M8145 : Y000 pulse output stop (immediate)
M8146 : Y001 pulse output stop (immediate)
M8147 : Y000 pulse output monitor (BUS/READY)
M8148 : Y001 pulse output monitor (BUS/READY)
Variable speed
puls output
Function
K,H,
KnX,KnY,
KnM,KnS
T,C,D,V,Z
Operation:
This is a variable speed output pulse instruction,
with a rotation direction output.
S
1
] of, 16-bit 10 to 32,767Hz or 32-bit 10 to
Y
Note:
Y000 or
Y001 only
Operands
D1
1
].
Y,M,S
2
] = OFF, rotation = negative, if
D2
PLSV
9 steps
DPLSV
17 steps
Applied Instructions 5
Program steps
5-129