FX1S-30MR-ES/UL MITSUBISHI, FX1S-30MR-ES/UL Datasheet - Page 186

• Manufacturer Part Number: FX1S-30MR-ES/UL
• Description: PLC, 16 IN, 14 RELAY OUT, 110V/2
• Manufacturer: MITSUBISHI

Specifications of FX1S-30MR-ES/UL

• No. Of Analogue Inputs: 16
• No. Of Analogue Outputs: 14
• Ip/nema Rating: IP10
• Approval Bodies: CE, CUL, UL
• External Depth: 49mm
• External Length / Height: 90mm
• External Width: 60mm
• Mounting Type: Panel

FX Series Programmable Controlers
e) Two FNC 59 (PLSR) can be used at the same time in a program to output pulses to Y000
f) If the number of pulses is not enough to reach the maximum frequency then the frequency is
g) Special auxiliary coil M8029 turns ON when the specified number of pulses has been
Acceleration time limitations
The acceleration time S
determined by other parameters of the system according to the following 4 points.
1) Set S3 to be more than 10 times the maximum program scan time (D8012).
2) The following formula gives the minimum value for S
3) The following formula gives the maximum value for S
4) The pulse output always increments in 10 step up to the maximum frequency as shown on
If the parameters do not meet the above conditions, reduce the size of S
• Possible output frequency is limited to 2 to 20,000 Hz for FX
• If the drive signal is switch off, all output stops. When driven ON again, the process starts
• Even if the operands are changed during operation, the output profile does not change.
and Y001 respectively. Or, only one FNC 57 PLSY and one FNC 59 PLSR can be used
together in the active program at once, again outputting independant pulses to Y000 and
Y001.
It is possible to use subroutines or other such programming techniques to isolate different
instances of this instructions. In this case, the current instruction must be deactivated before
changing to the new instance.
automatically cut
completed. The pulse count and completion flag (M8029) are reset when the PLSR
instruction is de-energized.
If set to less than this, then the timing of the acceleration steps becomes uneven.
the previous page.
100,000Hz for FX
are outside this limit then they are automatically adjusted to bring the value back to the
limit.
from the beginning.
The new values take effect from the next operation.
1S
/FX
3
has a maximum limit of 5000 ms. However, the actual limits of S
1N
S
S
. If either the maximum frequency or the acceleration step size
3
3
90000
S
S
S
1
2
1
818
5
3
3
.
.
2N
1
.
Applied Instructions 5
/FX
2NC
5-64
, and 10 to
3
are