st7pmc2s6 STMicroelectronics, st7pmc2s6 Datasheet - Page 172

• Manufacturer Part Number: st7pmc2s6
• Description: 8-bit Mcu For Automotive With Nested Interrupts, Flash, 10-bit Adc, Brushless Motor Control, 5 Timers, Spi, Linsci?
• Manufacturer: STMicroelectronics

On-chip peripherals
172/371
Table 69.
1. Bits 7:3 and bit 0 have the same function as in SCI mode; please refer to
SCI control register 2 (SCICR2)
Table 70.
Bit Name
SCICR2
Bit Name
4
3
2
1
0
7
6
on page
R/W
TIE
WAKE
7
TCIE
PCE
PIE
TIE
M
-
153.
Transmitter interrupt enable
Transmission complete interrupt enable
Word length
Wake-up method
Parity control enable
Reserved, must be kept cleared
Parity interrupt enable
SCICR1 register description
SCICR2 register description
This bit is set and cleared by software.
0: Interrupt is inhibited
1: An SCI interrupt is generated whenever TDRE = 1 in the SCISR register
This bit is set and cleared by software.
0: Interrupt is inhibited
1: An SCI interrupt is generated whenever TC = 1 in the SCISR register
This bit determines the word length. It is set or cleared by software.
0: 1 start bit, 8 data bits, 1 stop bit
1: 1 start bit, 9 data bits, 1 stop bit
Note: The M bit must not be modified during a data transfer (both transmission and
reception).
This bit determines the SCI wake-up method. It is set or cleared by software.
0: Idle line
1: Address mark
Note: If the LINE bit is set, the WAKE bit is deactivated and replaced by the LHDM bit.
This bit is set and cleared by software. It selects the hardware parity control for LIN
identifier parity check.
0: Parity control disabled
1: Parity control enabled
When a parity error occurs, the PE bit in the SCISR register is set.
This bit enables the interrupt capability of the hardware parity control when a parity
error is detected (PE bit set). The parity error involved can be a byte parity error (if bit
PCE is set and bit LPE is reset) or a LIN parity error (if bit PCE is set and bit LPE is
set).
0: Parity error interrupt disabled
1: Parity error interrupt enabled
TCIE
R/W
6
ST7MC1K2-Auto, ST7MC1K6-Auto, ST7MC2S4-Auto, ST7MC2S6-Auto
R/W
RIE
5
R/W
ILIE
4
(1)
(1)
(continued)
Function
Function
R/W
TE
3
R/W
RE
SCI control register 1 (SCICR1)
2
Reset value: 0000 0000 (00h)
RWU
R/W
1
SBK
R/W
0