HD6412373R RENESAS [Renesas Technology Corp], HD6412373R Datasheet - Page 267

• Manufacturer Part Number: HD6412373R
• Description: Renesas 16-Bit Single-Chip Microcomputer H8S Family/H8S/2300 Series
• Manufacturer: RENESAS [Renesas Technology Corp]

Section 6 Bus Controller (BSC)
6.6.9
Wait Control
There are two ways of inserting wait states in a DRAM access cycle: program wait insertion and
pin wait insertion using the WAIT pin.
Wait states are inserted to extend the CAS assertion period in a read access to DRAM space, and
to extend the write data setup time relative to the falling edge of CAS in a write access.
Program Wait Insertion: When the bit in ASTCR corresponding to an area designated as DRAM
space is set to 1, from 0 to 7 wait states can be inserted automatically between the T
state and T
c1
c2
state, according to the settings in WTCR.
Pin Wait Insertion: When the WAITE bit in BCR is set to 1 and the ASTCR bit is set to 1, wait
input by means of the WAIT pin is enabled. When DRAM space is accessed in this state, a
) is first inserted. If the WAIT pin is low at the falling edge of φ in the last T
program wait (T
or
w
c1
state is inserted. If the WAIT pin is held low, T
T
state, another T
states are inserted until it
w
w
w
goes high.
Figures 6.26 and 6.27 show examples of wait cycle insertion timing in the case of 2-state and 3-
state column address output cycles.
Rev.7.00 Mar. 18, 2009 page 199 of 1136
REJ09B0109-0700