HD6432646 Hitachi, HD6432646 Datasheet - Page 495

• Manufacturer Part Number: HD6432646
• Description: (HD64F264x Series) 16-Bit Microcomputer
• Manufacturer: Hitachi

13.3.2
In asynchronous mode, characters are sent or received, each preceded by a start bit indicating the
start of communication and stop bits indicating the end of communication. Serial communication
is thus carried out with synchronization established on a character-by-character basis.
Inside the SCI, the transmitter and receiver are independent units, enabling full-duplex
communication. Both the transmitter and the receiver also have a double-buffered structure, so
that data can be read or written during transmission or reception, enabling continuous data
transfer.
Figure 13-2 shows the general format for asynchronous serial communication.
In asynchronous serial communication, the transmission line is usually held in the mark state (high
level). The SCI monitors the transmission line, and when it goes to the space state (low level),
recognizes a start bit and starts serial communication.
One serial communication character consists of a start bit (low level), followed by data (in LSB-
first order), a parity bit (high or low level), and finally stop bits (high level).
In asynchronous mode, the SCI performs synchronization at the falling edge of the start bit in
reception. The SCI samples the data on the 8th pulse of a clock with a frequency of 16 times the
length of one bit, so that the transfer data is latched at the center of each bit.
Serial
data
1
Operation in Asynchronous Mode
Start
bit
1 bit
0
LSB
Figure 13-2 Data Format in Asynchronous Communication
D0
One unit of transfer data (character or frame)
(Example with 8-Bit Data, Parity, Two Stop Bits)
D1
D2
Transmit/receive data
D3
7 or 8 bits
D4
D5
D6
MSB
D7
Parity
bit
1 bit,
or none
0/1
Stop bit
1
1 or
2 bits
1
Idle state
(mark state)
1
461