AT91SAM7S256D-AU Atmel, AT91SAM7S256D-AU Datasheet - Page 667

• Manufacturer Part Number: AT91SAM7S256D-AU
• Description: ARM Microcontrollers - MCU 256K Flash SRAM 64K ARM based MCU
• Manufacturer: Atmel
• Series: SAM7S256r

Specifications of AT91SAM7S256D-AU

• Rohs: yes
• Core: ARM
• Processor Series: AT91SAM
• Data Bus Width: 16 bit/32 bit
• Maximum Clock Frequency: 55 MHz
• Program Memory Size: 256 KB
• Data Ram Size: 64 KB
• On-chip Adc: Yes
• Operating Supply Voltage: 3 V to 3.6 V
• Operating Temperature Range: - 40 C to + 85 C
• Package / Case: LQFP-64
• Mounting Style: SMD/SMT
• Interface Type: 2-Wire, I2S, SPI, USART
• Length: 7 mm

40.13.1.7
40.13.1.8
40.13.1.9
40.13.1.10
40.13.1.11
40.13.2
40.13.2.1
GOVRE should be set but is not.
None
When disabling channel “y” at the same instant as an end of conversion on channel “x”, EOC[x] and DRDY being
already active, GOVRE does not rise.
Note:
None
When the OVRE flag (on channel i) has been set but the related EOC status (of channel i) has been cleared (by a
read of CDRi or LCDR), reading the Status register at the same instant as an end of conversion (causing the set of
EOC status on channel i), does not lead to a reset of the OVRE flag (on channel i) as expected.
None
If a channel is disabled while a conversion is running and if a read of CDR is performed at the same time as an end
of conversion of any channel occurs, the EOC of the channel with the conversion running may rise (whereas it has
been disabled).
Do not take into account the EOC of a disabled channel
If “x” and “y” are two successively converted channels and “z” is yet another enabled channel (“z” being neither “x”
nor “y”), reading CDR on channel “z” at the same instant as an end of conversion on channel “y” automatically
clears EOC[x] instead of EOC[z].
None.
If Sleep mode is activated while there is no activity (no conversion is being performed), it will take effect only after
a conversion occurs.
To activate sleep mode as soon as possible, it is recommended to write successively, ADC Mode Register
(SLEEP) then ADC Control Register (START bit field); to start an analog-to-digital conversion, in order put ADC
into sleep mode at the end of this conversion.
The maximum number of write/erase cycles for Non Volatile Memory bits is 100. This includes Lock Bits (LOCKx),
General Purpose NVM bits (GPNVMx) and the Security Bit.
• GOVRE inactive,
• previous data stored in LCDR being neither data from channel “y”, nor data from channel “x”.
Non Volatile Memory Bits (NVM Bits)
Problem Fix/Workaround
Problem Fix/Workaround
Problem Fix/Workaround:
Problem Fix/Workaround
Problem Fix/Workaround
Problem Fix/Workaround
ADC: GOVRE Bit is not Set when Disabling a Channel
ADC: OVRE Flag Behavior
ADC: EOC Set although Channel Disabled
ADC: Spurious Clear of EOC Flag
ADC: Sleep Mode
NVM Bits: Write/Erase Cycles Number
OVRE[x] rises as expected.
SAM7S Series [DATASHEET]
6175M–ATARM–26-Oct-12
667