LSI53C825AJ LSI, LSI53C825AJ Datasheet - Page 158

• Manufacturer Part Number: LSI53C825AJ
• Manufacturer: LSI

Specifications of LSI53C825AJ

• Lead Free Status / RoHS Status: Not Compliant

4-70
SSM
IRQM
STD
IRQD
Registers
Single Step Mode
Setting this bit causes the LSI53C825A to stop after
executing each SCRIPTS instruction, and generate a
single step interrupt. When this bit is cleared the
LSI53C825A does not stop after each instruction. It
continues fetching and executing instructions until an
interrupt condition occurs. For normal SCSI SCRIPTS
operation, keep this bit cleared. To restart the
LSI53C825A after it generates a SCRIPTS Step interrupt,
read the
(DSTAT)
Then set the START DMA bit in this register.
IRQ Mode
When set, this bit enables a totem pole driver for the IRQ
pin. When cleared, this bit enables an open drain driver
for the IRQ pin with an internal weak pull-up. The bit
should remain cleared to retain full PCI compliance.
Start DMA Operation
The LSI53C825A fetches a SCSI SCRIPTS instruction
from the address contained in the
(DSP)
the LSI53C825A is in one of the following modes:
When the LSI53C825A is executing SCRIPTS in manual
start mode, the Start DMA bit must be set to start
instruction fetches, but need not be set again until an
interrupt occurs. When the LSI53C825A is in single step
mode, set the Start DMA bit to restart execution of
SCRIPTS after a single step interrupt.
IRQ Disable
Setting this bit disables the IRQ pin. Clearing the bit
enables normal operation. As with any other register
other than
be accessed except by a SCRIPTS instruction during
SCRIPTS execution. For more information on the use of
this bit in interrupt handling, see
Description.”
Manual start mode – Bit 0 in the
(DMODE)
Single step mode – Bit 4 in the
register is set
register when this bit is set. This bit is required if
registers to recognize and clear the interrupt.
Interrupt Status (ISTAT)
Interrupt Status
register is set
(ISTAT), this register cannot
Chapter 2, “Functional
and
DMA SCRIPTS Pointer
DMA Control (DCNTL)
DMA Mode
DMA Status
4
3
2
1