HD6473937RXV Renesas Electronics America, HD6473937RXV Datasheet - Page 123

• Manufacturer Part Number: HD6473937RXV
• Description: MCU 3/5V 60K 100-TQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8/300L SLPr

Specifications of HD6473937RXV

• Core Processor: H8/300L
• Core Size: 8-Bit
• Speed: 10MHz
• Connectivity: SCI
• Peripherals: POR, WDT
• Number Of I /o: 59
• Program Memory Size: 60KB (60K x 8)
• Program Memory Type: OTP
• Ram Size: 2K x 8
• Voltage - Supply (vcc/vdd): 1.8 V ~ 3.6 V
• Data Converters: A/D 8x10b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-TQFP, 100-VQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

5.4
5.4.1
The system goes from active or subactive mode to watch mode when a SLEEP instruction is
executed while the SSBY bit in SYSCR1 is set to 1 and bit TMA3 in TMA is set to 1.
In watch mode, operation of on-chip peripheral modules is halted except for timer A, timer F,
timer G, and the FLEX™ decoder. As long as a minimum required voltage is applied, the
contents of CPU registers, the on-chip RAM and some registers of the on-chip peripheral modules,
are retained. I/O ports keep the same states as before the transition.
5.4.2
Watch mode is cleared by an interrupt (timer A, timer F, timer G, IRQ
input at the RES pin.
When watch mode is cleared by interrupt, the mode to which a transition is made depends on the
settings of LSON in SYSCR1 and MSON in SYSCR2. If both LSON and MSON are cleared to 0,
transition is to active (high-speed) mode; if LSON = 0 and MSON = 1, transition is to active
(medium-speed) mode; if LSON = 1, transition is to subactive mode. When the transition is to
active mode, after the time set in SYSCR1 bits STS2 to STS0 has elapsed, a stable clock signal is
supplied to the entire chip, watch mode is cleared, and interrupt exception handling starts. Watch
mode is not cleared if the I bit of CCR is set to 1 or the particular interrupt is disabled in the
interrupt enable register.
Clearing by RES pin is the same as for standby mode; see 2. Clearing by RES pin in 5.3.2,
Clearing Standby Mode.
5.4.3
The waiting time is the same as for standby mode; see 5.3.3, Oscillator Settling Time after
Standby Mode is Cleared.
5.4.4
See 5.3.5, Notes on External Input Signal Changes before/after Standby Mode.
Clearing by interrupt
Clearing by RES input
Watch Mode
Transition to Watch Mode
Clearing Watch Mode
Oscillator Settling Time after Watch Mode is Cleared
Notes on External Input Signal Changes before/after Watch Mode
0
, or WKP
7
to WKP
0
) or by
109