TMPA901CMXBG Toshiba, TMPA901CMXBG Datasheet - Page 550

• Manufacturer Part Number: TMPA901CMXBG
• Description: Microcontrollers (MCU) 32-bit RISC MCU 16kb ARM926EJ 16kb 200Mhz
• Manufacturer: Toshiba

Specifications of TMPA901CMXBG

• Product Summaries: Summary
• Lead Free: Yes
• Rohs Compatible Product(s): Available
• Rom (kbytes): -
• Rom Type: ROMless
• Ram (kbytes): 32
• Number Of Pins: 177
• Package: BGA
• Vcc: 3V
• Tft Lcd Controller: Y
• Touchscreen Controller: Y
• Usb Host Fs With Phy: Y
• Usb Device Hs With Phy: Y
• Sd Host Controller: -
• Cmos Image Sensor Interface: -
• I2s: 1
• Ssp (ch) Spi: 1
• I2mc/sio (ch): 1
• Uart/sio (ch): 2
• External Bus Interface: Y
• Cs/wait Controller (ch): 4
• Dma Controller: 8
• 10-bit Ad Converter: 4
• 12-bit Da Converter: -
• 16-bit Timer / Counter: 6
• Real Time Clock: Y
• Watchdog Timer: Y
• Osc Freq Detect: Y
• Low-power Modes: Y
• Lead Free Status / Rohs Status: Details

bmRequestType
0y00000000
0y00000001
0y00000010
Common to all states:
Default state:
Address state:
Configured state:
Note: Endpoint 0 is to be stalled based on the interpretation of the USB 2.0 specifications that "No Feature Selector
(b) Clear Feature request
exists for Interface" here. For more information, see the USB Specification.
If Feature Selector (wValue) which cannot be cleared (disabled) or does not exist is
specified, issue the EP-Stall command to EP0.
If the Endpoint/Interface specified by wIndex does not exist, issue the EP-Stall
command to EP0.
Nothing is specified for the operation of devices by the USB 2.0 specifications.
CLEAR_FEATURE
bRequest
Recipient = Endpoint
Recipient = Device
Recipient = Interface
Recipient = Endpoint
Recipient = Device
Recipient = Interface
To this request, particular functions are cleared or disabled.
Feature Selector
wValue
TMPA901CM- 549
:
:
:
:
:
:
If wIndex ≠ 0 (EPx), issue the EP-Stall command
If wValue = 0 and wIndex ≠ 0 (EPx), issue the
If wValue = 1, disable the
DEVICE_REMOTE_WAKEUP function at the
user's end. No register access to UDC2 is
required.
Issue the EP-Stall command to EP0.
to EP0.
If wValue = 0 and wIndex = 0 (EP0), clear the
Halt state of Endpoint 0 but no register access to
UDC2 is required.
If wValue = 1, disable the
DEVICE_REMOTE_WAKEUP function at the
user's end. No register access to UDC2 is
required.
Issue the EP-Stall command to EP0. (Note)
EP-Reset command to relevant endpoint. If
wValue = 0 and wIndex = 0 (EP0), clear the Halt
state of Endpoint 0 but no register access to
UDC2 is required.
wIndex
Interface
Endpoint
Zero
wLength
Zero
TMPA901CM
2010-07-29
Data
None