SAM7SE256 Atmel Corporation, SAM7SE256 Datasheet - Page 416

• Manufacturer Part Number: SAM7SE256
• Manufacturer: Atmel Corporation

Specifications of SAM7SE256

• Flash (kbytes): 256 Kbytes
• Pin Count: 144
• Max. Operating Frequency: 48 MHz
• Cpu: ARM7TDMI
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 88
• Ext Interrupts: 88
• Usb Transceiver: 1
• Usb Speed: Full Speed
• Usb Interface: Device
• Spi: 1
• Twi (i2c): 1
• Uart: 3
• Ssc: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 8
• Adc Resolution (bits): 10
• Adc Speed (ksps): 384
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 32
• Self Program Memory: NO
• External Bus Interface: 1
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 3.0 to 3.6
• Fpu: No
• Mpu / Mmu: Yes / No
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

33.6.8.2
33.6.8.3
33.6.8.4
416
SAM7SE512/256/32
Automatic Echo Mode
Local Loopback Mode
Remote Loopback Mode
Figure 33-28. Normal Mode Configuration
Automatic echo mode allows bit-by-bit retransmission. When a bit is received on the RXD pin, it
is sent to the TXD pin, as shown in
the TXD pin. The RXD pin is still connected to the receiver input, thus the receiver remains
active.
Figure 33-29. Automatic Echo Mode Configuration
Local loopback mode connects the output of the transmitter directly to the input of the receiver,
as shown in
the receiver and the TXD pin is continuously driven high, as in idle state.
Figure 33-30. Local Loopback Mode Configuration
Remote loopback mode directly connects the RXD pin to the TXD pin, as shown in
The transmitter and the receiver are disabled and have no effect. This mode allows bit-by-bit
retransmission.
Figure
33-30. The TXD and RXD pins are not used. The RXD pin has no effect on
Transmitter
Transmitter
Transmitter
Receiver
Receiver
Receiver
Figure
33-29. Programming the transmitter has no effect on
1
RXD
TXD
RXD
TXD
RXD
TXD
6222F–ATARM–14-Jan-11
Figure
33-31.