SAM7SE256 Atmel Corporation, SAM7SE256 Datasheet - Page 569

• Manufacturer Part Number: SAM7SE256
• Manufacturer: Atmel Corporation

Specifications of SAM7SE256

• Flash (kbytes): 256 Kbytes
• Pin Count: 144
• Max. Operating Frequency: 48 MHz
• Cpu: ARM7TDMI
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 88
• Ext Interrupts: 88
• Usb Transceiver: 1
• Usb Speed: Full Speed
• Usb Interface: Device
• Spi: 1
• Twi (i2c): 1
• Uart: 3
• Ssc: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 8
• Adc Resolution (bits): 10
• Adc Speed (ksps): 384
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 32
• Self Program Memory: NO
• External Bus Interface: 1
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 3.0 to 3.6
• Fpu: No
• Mpu / Mmu: Yes / No
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

38.5.2.9
38.5.2.10
38.5.2.11
6222F–ATARM–14-Jan-11
Transmit Data Cancellation
Endpoints Without Dual-Banks
Endpoints With Dual-Banks
Some endpoints have dual-banks whereas some endpoints have only one bank. The procedure
to cancel transmission data held in these banks is described below.
To see the organization of dual-bank availability refer to
There are two possibilities: In one case, TXPKTRDY field in UDP_CSR has already been set. In
the other instance, TXPKTRDY is not set.
There are two possibilities: In one case, TXPKTRDY field in UDP_CSR has already been set. In
the other instance, TXPKTRDY is not set.
• TXPKTRDY is not set:
• TXPKTRDY has already been set:
• TXPKTRDY is not set:
• TXPKTRDY has already been set:
– Reset the endpoint to clear the FIFO (pointers). (See
– Clear TXPKTRDY so that no packet is ready to be sent
– Reset the endpoint to clear the FIFO (pointers). (See
– Reset the endpoint to clear the FIFO (pointers). (See
– Clear TXPKTRDY and read it back until actually read at 0.
– Set TXPKTRDY and read it back until actually read at 1.
– Clear TXPKTRDY so that no packet is ready to be sent.
– Reset the endpoint to clear the FIFO (pointers). (See
Endpoint
Endpoint
Endpoint
Endpoint
Register”.)
Register”.)
Register”.)
Register”.)
Table 38-1 ”USB Endpoint
SAM7SE512/256/32
Section 38.6.9 ”UDP Reset
Section 38.6.9 ”UDP Reset
Section 38.6.9 ”UDP Reset
Section 38.6.9 ”UDP Reset
Description”.
569