R5S72611 RENESAS [Renesas Technology Corp], R5S72611 Datasheet - Page 758

no-image

R5S72611

Manufacturer Part Number
R5S72611
Description
32-Bit RISC Microcomputer SuperHTM RISC engine Family / SH7260 Series
Manufacturer
RENESAS [Renesas Technology Corp]
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
R5S72611P100FP
Manufacturer:
ACTEL
Quantity:
90
Part Number:
R5S72611P100FP
Manufacturer:
RENESAS/瑞萨
Quantity:
20 000
Part Number:
R5S72611P100FPV
Manufacturer:
RENESAS/瑞萨
Quantity:
20 000
Part Number:
R5S72611RB120FPV
Manufacturer:
RENESAS/瑞萨
Quantity:
20 000
Section 16 Serial Communication Interface with FIFO (SCIF)
16.6
Note the following when using the SCIF.
16.6.1
The TDFE flag in the serial status register (SCFSR) is set when the number of transmit data bytes
written in the transmit FIFO data register (SCFTDR) has fallen below the transmit trigger number
set by bits TTRG1 and TTRG0 in the FIFO control register (SCFCR). After TDFE is set, transmit
data up to the number of empty bytes in SCFTDR can be written, allowing efficient continuous
transmission.
However, if the number of data bytes written in SCFTDR is equal to or less than the transmit
trigger number, the TDFE flag will be set to 1 again after being read as 1 and cleared to 0. TDFE
clearing should therefore be carried out when SCFTDR contains more than the transmit trigger
number of transmit data bytes.
The number of transmit data bytes in SCFTDR can be found from the upper 8 bits of the FIFO
data count register (SCFDR).
16.6.2
The RDF flag in the serial status register (SCFSR) is set when the number of receive data bytes in
the receive FIFO data register (SCFRDR) has become equal to or greater than the receive trigger
number set by bits RTRG1 and RTRG0 in the FIFO control register (SCFCR). After RDF is set,
receive data equivalent to the trigger number can be read from SCFRDR, allowing efficient
continuous reception.
However, if the number of data bytes in SCFRDR exceeds the trigger number, the RDF flag will
be set to 1 again if it is cleared to 0. RDF should therefore be cleared to 0 after being read as 1
after reading the number of the received data in the receive FIFO data register (SCFRDR) which is
less than the trigger number.
The number of receive data bytes in SCFRDR can be found from the lower 8 bits of the FIFO data
count register (SCFDR).
Rev. 2.00 Sep. 07, 2007 Page 726 of 1312
REJ09B0320-0200
Usage Notes
SCFTDR Writing and TDFE Flag
SCFRDR Reading and RDF Flag

Related parts for R5S72611