DF2134AFA20V Renesas Electronics America, DF2134AFA20V Datasheet - Page 576

• Manufacturer Part Number: DF2134AFA20V
• Description: IC H8S/2100 MCU FLASH 80QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2100r

Specifications of DF2134AFA20V

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: IrDA, SCI
• Peripherals: POR, PWM, WDT
• Number Of I /o: 58
• Program Memory Size: 128KB (128K x 8)
• Program Memory Type: FLASH
• Ram Size: 4K x 8
• Voltage - Supply (vcc/vdd): 4 V ~ 5.5 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 80-QFP
• For Use With: 3DK2166 - DEV EVAL KIT H8S/2166
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

Section 16 I
Rev. 4.00 Jun 06, 2006 page 520 of 1004
REJ09B0301-0400
Notes on TRS Bit Setting and ICDR Register Access
Conditions to cause this failure
Low-fixation of the SCL pins is cancelled incorrectly when the following conditions are
satisfied.
Restriction
Please carry out the following countermeasures when transmitting/receiving via the IIC bus
interface module.
(1) Please read the ICDR registers in receive mode, and write them in transmit mode.
(2) In receiving operation with master mode, please issue the start condition after clearing the
Master mode
Figure 16.26 shows the notes on ICDR reading (TRS = 1) in master mode.
(1) When previously received 2-bytes data remains in ICDR unread (ICDRS are full).
(2) Reads ICDR register after switching to transmit mode (TRS = 1). (RDRF = 0 state)
(3) Sets to receive mode (TRS = 0), after transmitting Rev.1 frame of issued start condition
Slave mode
Figure 16.27 shows the notes on ICDR writing (TRS = 0) in slave mode.
(1) Writes ICDR register in receive mode (TRS = 0), after entering the start condition by
internal flag of the IIC bus interface module, using CLR3 to CLR0 bit of the DDCSWR
register on bus-free state (BBSY = 0).
by master mode.
slave mode (TDRE = 0 state).
Address match with Rev.1 frame, receive 1 by R/W bit, and switches to transmit mode
(TRS = 1).
When these conditions are satisfied, the low fixation of the SCL pins is cancelled
without ICDR register access after Rev.1 frame is transferred.
2
C Bus Interface [H8S/2138 Group Option]