DF2239TF16I Renesas Electronics America, DF2239TF16I Datasheet - Page 624

• Manufacturer Part Number: DF2239TF16I
• Description: MCU 3V 384K I-TEMP 100-TQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2200r

Specifications of DF2239TF16I

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 16MHz
• Connectivity: I²C, SCI, SmartCard
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 72
• Program Memory Size: 384KB (384K x 8)
• Program Memory Type: FLASH
• Ram Size: 32K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 3.6 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 100-TQFP, 100-VQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Other names: HD64F2239TF16I; HD64F2239TF16I

Section 15 Serial Communication Interface (SCI)
Legend:
×: Don’t care
Rev. 6.00 Mar. 18, 2010 Page 562 of 982
REJ09B0054-0600
Bit
3
2
1
0
Bit Name
MPIE
TEIE
CKE1
CKE0
Initial
Value
0
0
0
0
R/W
R/W
R/W
R/W
Description
Multiprocessor Interrupt Enable (enabled only
when the MP bit in SMR is 1 in asynchronous
mode)
Write 0 to this bit in Smart Card interface mode.
When receive data including MPB = 0 is received,
receive data transfer from RSR to RDR, receive
error detection, and setting of the RERF, FER, and
ORER flags in SSR, are not performed.
When receive data including MPB = 1 is received,
the MPB bit in SSR is set to 1, the MPIE bit is
cleared to 0 automatically, and generation of RXI
and ERI interrupts (when the TIE and RIE bits in
SCR are set to 1) and FER and ORER flag setting
are enabled.
Transmit End Interrupt Enable
Write 0 to this bit in Smart Card interface mode.
TEI cancellation can be performed by reading 1
from the TDRE flag in SSR, then clearing it to 0
and clearing the TEND flag to 0, or clearing the
TEIE bit to 0.
Clock Enable 0 and 1
Enables or disables clock output from the SCK pin.
The clock output can be dynamically switched in
GSM mode. For details, refer to section 15.7.8,
Clock Output Control.
When the GM bit in SMR is 0:
00: Output disabled (SCK pin can be used as an
01: Clock output
1×: Reserved
When the GM bit in SMR is 1:
00: Output fixed low
01: Clock output
10: Output fixed high
11: Clock output
I/O port pin)