sc9s12hy64j0vllr Freescale Semiconductor, Inc, sc9s12hy64j0vllr Datasheet - Page 184

• Manufacturer Part Number: sc9s12hy64j0vllr
• Description: S12 Microcontrollers Mcu 16-bit Hcs12 Cisc 32kb Flash 5v Tray
• Manufacturer: Freescale Semiconductor, Inc

S12S Debug Module (S12SDBGV2)
Tag: Tags can be attached to CPU opcodes as they enter the instruction pipe. If the tagged opcode reaches
the execution stage a tag hit occurs.
6.1.2
The comparators monitor the bus activity of the CPU module. A match can initiate a state sequencer
transition. On a transition to the Final State, bus tracing is triggered and/or a breakpoint can be generated.
Independent of comparator matches a transition to Final State with associated tracing and breakpoint can
be triggered immediately by writing to the TRIG control bit.
The trace buffer is visible through a 2-byte window in the register address map and can be read out using
standard 16-bit word reads. Tracing is disabled when the MCU system is secured.
6.1.3
184
•
•
•
•
•
•
•
Three comparators (A, B and C)
— Comparators A compares the full address bus and full 16-bit data bus
— Comparator A features a data bus mask register
— Comparators B and C compare the full address bus only
— Each comparator features selection of read or write access cycles
— Comparator B allows selection of byte or word access cycles
— Comparator matches can initiate state sequencer transitions
Three comparator modes
— Simple address/data comparator match mode
— Inside address range mode, Addmin Address Addmax
— Outside address range match mode, Address Addmin or Address Addmax
Two types of matches
— Tagged — This matches just before a specific instruction begins execution
— Force — This is valid on the first instruction boundary after a match occurs
Two types of breakpoints
— CPU breakpoint entering BDM on breakpoint (BDM)
— CPU breakpoint executing SWI on breakpoint (SWI)
Trigger mode independent of comparators
— TRIG Immediate software trigger
Four trace modes
— Normal: change of flow (COF) PC information is stored (see 6.4.5.2.1) for change of flow
— Loop1: same as Normal but inhibits consecutive duplicate source address entries
— Detail: address and data for all cycles except free cycles and opcode fetches are stored
— Compressed Pure PC: all program counter addresses are stored
4-stage state sequencer for trace buffer control
— Tracing session trigger linked to Final State of state sequencer
definition.
Overview
Features
MC9S12HY/HA-Family Reference Manual, Rev. 1.04
Freescale Semiconductor