s3c2410a Samsung Semiconductor, Inc., s3c2410a Datasheet - Page 350

• Manufacturer Part Number: s3c2410a
• Description: 16/32-bit Risc Arm Microprocessor
• Manufacturer: Samsung Semiconductor, Inc.

INTERRUPT CONTROLLER
S3C2410A
INTERRUPT CONTROLLER OPERATION
F-bit and I-bit of Program Status Register (PSR)
If the F-bit of PSR in ARM920T CPU is set to 1, the CPU does not accept the Fast Interrupt Request (FIQ) from the
interrupt controller. Likewise, If I-bit of the PSR is set to 1, the CPU does not accept the Interrupt Request (IRQ) from
the interrupt controller. So, the interrupt controller can receive interrupts by clearing F-bit or I-bit of the PSR to 0 and
setting the corresponding bit of INTMSK to 0.
Interrupt Mode
The ARM920T has two types of Interrupt mode: FIQ or IRQ. All the interrupt sources determine which mode is used
at interrupt request.
Interrupt Pending Register
The S3C2410A has two interrupt pending resisters: source pending register (SRCPND) and interrupt pending register
(INTPND). These pending registers indicate whether or not an interrupt request is pending. When the interrupt
sources request interrupt service, the corresponding bits of SRCPND register are set to 1, and at the same time,
only one bit of the INTPND register is set to 1 automatically after arbitration procedure. If interrupts are masked, the
corresponding bits of the SRCPND register are set to 1. This does not cause the bit of INTPND register changed.
When a pending bit of the INTPND register is set, the interrupt service routine starts whenever the I-flag or F-flag is
cleared to 0. The SRCPND and INTPND registers can be read and written, so the service routine must clear the
pending condition by writing a 1 to the corresponding bit in the SRCPND register first and then clear the pending
condition in the INTPND registers by using the same method.
Interrupt Mask Register
This register indicates that an interrupt has been disabled if the corresponding mask bit is set to 1. If an interrupt
mask bit of INTMSK is 0, the interrupt will be serviced normally. If the corresponding mask bit is 1 and the interrupt is
generated, the source pending bit will be set.
14-2