R0K572115S000BE Renesas Electronics America, R0K572115S000BE Datasheet - Page 105

• Manufacturer Part Number: R0K572115S000BE
• Description: KIT STARTER FOR SH7211
• Manufacturer: Renesas Electronics America
• Series: Renesas Starter Kits (RSK)r
• Type: Microcontrollerr

Specifications of R0K572115S000BE

• Contents: CPU Board, LCD Display Module, E8 Emulator, Cable, QuickStart Guide and CD-ROM
• For Use With/related Products: SH7211
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

5.1.2
The exception handling sources are detected and begin processing according to the timing shown
in table 5.2.
Table 5.2
Exception
Reset
Address error
Interrupts
Register bank
error
Instructions
Exception Handling Operations
Timing of Exception Source Detection and Start of Exception Handling
Source
Power-on reset
Manual reset
Bank underflow
Bank overflow
Trap instruction
General illegal
instructions
Slot illegal
instructions
Integer division
instructions
Timing of Source Detection and Start of Handling
Starts when the RES pin changes from low to high, when the
H-UDI reset negate command is set after the H-UDI reset
assert command has been set, or when the WDT overflows.
Starts when the MRES pin changes from low to high or when
the WDT overflows.
Detected when instruction is decoded and starts when the
previous executing instruction finishes executing.
Detected when instruction is decoded and starts when the
previous executing instruction finishes executing.
Starts upon attempted execution of a RESBANK instruction
when saving has not been performed to register banks.
In the state where saving has been performed to all register
bank areas, starts when acceptance of register bank overflow
exception has been set by the interrupt controller (the BOVE bit
in IBNR of the INTC is 1) and an interrupt that uses a register
bank has occurred and been accepted by the CPU.
Starts from the execution of a TRAPA instruction.
Starts from the decoding of undefined code anytime except
immediately after a delayed branch instruction (delay slot).
Starts from the decoding of undefined code placed immediately
after a delayed branch instruction (delay slot), of instructions
that rewrite the PC, of 32-bit instructions, of the RESBANK
instruction, of the DIVS instruction, or of the DIVU instruction.
Starts when detecting division-by-zero exception or overflow
exception caused by division of the negative maximum value
(H'80000000) by −1.
Rev. 3.00 Mar. 04, 2009 Page 79 of 1168
REJ09B0344-0300