R0K572115S000BE Renesas Electronics America, R0K572115S000BE Datasheet - Page 748

• Manufacturer Part Number: R0K572115S000BE
• Description: KIT STARTER FOR SH7211
• Manufacturer: Renesas Electronics America
• Series: Renesas Starter Kits (RSK)r
• Type: Microcontrollerr

Specifications of R0K572115S000BE

• Contents: CPU Board, LCD Display Module, E8 Emulator, Cable, QuickStart Guide and CD-ROM
• For Use With/related Products: SH7211
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

15.6.3
When the DMAC writes data to SCFTDR due to a TXI interrupt request, the state of the TEND
flag becomes undefined. Therefore, the TEND flag should not be used as the transfer end flag in
such a case.
15.6.4
Break signals can be detected by reading the RXD pin directly when a framing error (FER) is
detected. In the break state the input from the RXD pin consists of all 0s, so the FER flag is set
and the parity error flag (PER) may also be set.
Note that, although transfer of receive data to SCFRDR is halted in the break state, the SCIF
receiver continues to operate.
15.6.5
The I/O condition and level of the TXD pin are determined by the SPB2IO and SPB2DT bits in
the serial port register (SCSPTR). This feature can be used to send a break signal.
Until TE bit is set to 1 (enabling transmission) after initializing, the TXD pin does not work.
During the period, mark status is performed by the SPB2DT bit. Therefore, the SPB2IO and
SPB2DT bits should be set to 1 (high level output).
To send a break signal during serial transmission, clear the SPB2DT bit to 0 (designating low
level), then clear the TE bit to 0 (halting transmission). When the TE bit is cleared to 0, the
transmitter is initialized regardless of the current transmission state, and 0 is output from the TXD
pin.
Rev. 3.00 Mar. 04, 2009 Page 722 of 1168
REJ09B0344-0300
Restriction on DMAC Usage
Break Detection and Processing
Sending a Break Signal