R0K572115S000BE Renesas Electronics America, R0K572115S000BE Datasheet - Page 992

• Manufacturer Part Number: R0K572115S000BE
• Description: KIT STARTER FOR SH7211
• Manufacturer: Renesas Electronics America
• Series: Renesas Starter Kits (RSK)r
• Type: Microcontrollerr

Specifications of R0K572115S000BE

• Contents: CPU Board, LCD Display Module, E8 Emulator, Cable, QuickStart Guide and CD-ROM
• For Use With/related Products: SH7211
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

(5)
Command errors are generated by undefined commands, commands sent in an incorrect order, and
the inability to accept a command. For example, sending the clock-mode selection command
before device selection or an inquiry command after the transition-to-programming/erasure state
command generates a command error.
• Error response H'80 (1 byte): Command error
• Command H'xx (1 byte): Received command
(6)
In the inquiry-and-selection state, commands should be sent in the following order.
1. Send the inquiry on supported devices command (H'20) to get the list of supported devices.
2. Select a device from the returned device information, and send the device selection command
3. Send the inquiry on clock mode command (H'21) to get the available clock modes.
4. Select a clock mode from among the returned clock modes, and send the clock-mode selection
5. After selection of the device and clock mode, send the commands to inquire about frequency
6. Taking into account the returned information on the frequency multipliers and operating
7. After the device and clock mode have been selected, get the information required for
8. After making all necessary inquiries and the new bit rate selection, send the transition-to-
Rev. 3.00 Mar. 04, 2009 Page 966 of 1168
REJ09B0344-0300
Error
response
(H'10) to select that device.
command (H'11).
multipliers (H'22) and operating frequencies (H'23) to get the information required to select a
new bit rate.
frequencies, send a new-bit-rate selection command (H'3F).
programming and erasure of the user boot MAT and user MAT by sending the commands to
inquire about the user boot MAT (H'24), user MAT (H'25), erasure block (H'26), and
programming size (H'27).
programming/erasure state command (H'40) to place the boot program in the
programming/erasure state.
Command Error
Order of Commands
H'80
H'xx