HD64F7144F50V Renesas Electronics America, HD64F7144F50V Datasheet - Page 711

• Manufacturer Part Number: HD64F7144F50V
• Description: IC SUPERH MCU FLASH 256K 112QFP
• Manufacturer: Renesas Electronics America
• Series: SuperH® SH7144r

Specifications of HD64F7144F50V

• Core Processor: SH-2
• Core Size: 32-Bit
• Speed: 50MHz
• Connectivity: EBI/EMI, I²C, SCI
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 74
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 8K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 8x10b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 112-QFP
• For Use With: HS0005KCU11H - EMULATOR E10A-USB H8S(X),SH2(A)EDK7145 - DEV EVALUATION KIT SH7145
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

19.5
The flash memory has the following registers. For details on register addresses and register states
during each processing, refer to section 25, List of Registers.
• Flash memory control register 1 (FLMCR1)
• Flash memory control register 2 (FLMCR2)
• Erase block register 1 (EBR1)
• Erase block register 2 (EBR2)
• RAM emulation register (RAMER)
19.5.1
FLMCR1 is a register that makes the flash memory change to program mode, program-verify
mode, erase mode, or erase-verify mode. For details on register setting, refer to section 19.8, Flash
Memory Programming/Erasing.
Bit
7
6
5
4
Bit Name
FEW
SWE
ESU
PSU
Register Descriptions
Flash Memory Control Register 1 (FLMCR1)
Initial Value
1/0
0
0
0
R/W
R
R/W
R/W
R/W
Description
Flash Write Enable*
Reflects the input level at the FWP pin. It is set to 1
when a low level is input to the FWP pin, and cleared
to 0 when a high level is input.
Software Write Enable
When this bit is set to 1 while the FEW bit is 1, flash
memory programming/erasing is enabled. When this
bit is cleared to 0, other FLMCR1 bits and all EBR1
and EBR2 bits cannot be set.
Erase Setup
When this bit is set to 1 while the FEW and SWE bits
are 1, the flash memory changes to the erase setup
state. When it is cleared to 0, the erase setup state is
cancelled.
Program Setup
When this bit is set to 1 while the FEW and SWE bits
are 1, the flash memory changes to the program
setup state. When it is cleared to 0, the program
setup state is cancelled.
Rev.4.00 Mar. 27, 2008 Page 665 of 882
19. Flash Memory (F-ZTAT Version)
REJ09B0108-0400