M306N4FGGP#U3 Renesas Electronics America, M306N4FGGP#U3 Datasheet - Page 90

• Manufacturer Part Number: M306N4FGGP#U3
• Description: IC M16C/6N4 MCU FLASH 100-LQFP
• Manufacturer: Renesas Electronics America
• Series: M16C™ M16C/6Nr

Specifications of M306N4FGGP#U3

• Core Processor: M16C/60
• Core Size: 16-Bit
• Speed: 24MHz
• Connectivity: CAN, I²C, IEBus, SIO, UART/USART
• Peripherals: DMA, WDT
• Number Of I /o: 85
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 10K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 5.5 V
• Data Converters: A/D 26x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 100-LQFP
• Package: 100LQFP
• Family Name: M16C
• Maximum Speed: 24 MHz
• Operating Supply Voltage: 3.3|5 V
• Data Bus Width: 16|32 Bit
• Number Of Programmable I/os: 87
• Interface Type: I2C/UART
• On-chip Adc: 26-chx10-bit
• On-chip Dac: 2-chx8-bit
• Number Of Timers: 11
• For Use With: R0K3306NKS001BE - KIT DEV RSK RSK-M16C/6NKR0K3306NKS000BE - KIT DEV RSK RSK-M16C/6NK
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

M16C/6N Group (M16C/6N4)
Rev.2.40
REJ09B0009-0240
Table 8.5 Interrupts to Exit Wait Mode and Use Conditions
_______
NMI interrupt
Serial interface interrupt
Key input interrupt
A/D conversion interrupt
Timer A interrupt
Timer B interrupt
______
INT interrupt
CAN0/1 wake-up interrupt Can be used in CAN sleep mode
If the MCU exits wait mode by a peripheral function interrupt, set up the following before executing the
WAIT instruction.
(1) Set bits ILVL2 to ILVL0 in the interrupt control register, for peripheral function interrupts used to exit
(2) Set the I flag to 1.
(3) Start operating the peripheral functions used to exit wait mode.
When the MCU exits wait mode by the peripheral function interrupt, the CPU clock is the same clock as
the CPU clock executing the WAIT instruction.
Apr 14, 2006
wait mode.
Bits ILVL2 to ILVL0 in all other interrupt control registers, for peripheral function interrupts not used
to exit wait mode, are set to 000b (interrupt disabled).
When the peripheral function interrupt is used, an interrupt routine is performed as soon as an
interrupt request is acknowledged and the CPU clock is supplied again.
Interrupt
page 66 of 376
Can be used when operating with
Can be used
internal or external clock
Can be used
Can be used in one-shot mode or
single sweep mode
Can be used in all modes
Can be used
CM02 Bit = 0
Can be used when operating with
Can be used
external clock
Can be used
- (Do not use)
Can be used in event counter mode
or when the count source is fC32
Can be used
Can be used in CAN sleep mode
CM02 Bit = 1
8. Clock Generation Circuit