EVB9S12XEP100 Freescale Semiconductor, EVB9S12XEP100 Datasheet - Page 875

• Manufacturer Part Number: EVB9S12XEP100
• Description: BOARD EVAL FOR MC9S12XEP100
• Manufacturer: Freescale Semiconductor
• Type: MCUr

Specifications of EVB9S12XEP100

• Contents: Module and Misc Hardware
• Processor To Be Evaluated: MC9S12XEP100
• Data Bus Width: 16 bit
• Interface Type: RS-232
• Silicon Manufacturer: Freescale
• Core Architecture: S12
• Core Sub-architecture: S12
• Silicon Core Number: MC9S12
• Silicon Family Name: S12XE
• Rohs Compliant: Yes
• For Use With/related Products: MC9S12XEP100
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Upon clearing CCIF to launch the Erase All Blocks command, the Memory Controller will erase the entire
Flash memory space and verify that it is erased. If the Memory Controller verifies that the entire Flash
memory space was properly erased, security will be released. During the execution of this command
(CCIF=0) the user must not write to any Flash module register. The CCIF flag will set after the Erase All
Blocks operation has completed.
24.4.2.8
The Erase P-Flash Block operation will erase all addresses in a P-Flash block.
Upon clearing CCIF to launch the Erase P-Flash Block command, the Memory Controller will erase the
selected P-Flash block and verify that it is erased. The CCIF flag will set after the Erase P-Flash Block
operation has completed.
Freescale Semiconductor
1. As found in the memory map for FTM256K2.
FERSTAT
Register
FSTAT
Erase P-Flash Block Command
Table 24-47. Erase P-Flash Block Command FCCOB Requirements
CCOBIX[2:0]
CCOBIX[2:0]
Table 24-45. Erase All Blocks Command FCCOB Requirements
MGSTAT1
MGSTAT0
EPVIOLIF
ACCERR
Error Bit
FPVIOL
000
000
001
Table 24-46. Erase All Blocks Command Error Handling
MC9S12XE-Family Reference Manual , Rev. 1.23
Set if CCOBIX[2:0] != 000 at command launch
Set if command not available in current mode (see
Set if any area of the P-Flash memory is protected
Set if any errors have been encountered during the verify operation
Set if any non-correctable errors have been encountered during the verify
operation
Set if any area of the buffer RAM EEE partition is protected
Global address [15:0] in P-Flash block to be erased
1
0x08
0x09
FCCOB Parameters
FCCOB Parameters
Error Condition
Chapter 24 128 KByte Flash Module (S12XFTM128K2V1)
Global address [22:16] to
identify P-Flash block
Not required
Table
24-30)
(1)
875