HD6417144F50V Renesas Electronics America, HD6417144F50V Datasheet - Page 139

• Manufacturer Part Number: HD6417144F50V
• Description: IC SUPERH MCU ROMLESS 112QFP
• Manufacturer: Renesas Electronics America
• Series: SuperH® SH7144r

Specifications of HD6417144F50V

• Core Processor: SH-2
• Core Size: 32-Bit
• Speed: 50MHz
• Connectivity: EBI/EMI, I²C, SCI
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 74
• Program Memory Type: ROMless
• Ram Size: 8K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 8x10b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 112-QFP
• For Use With: HS0005KCU11H - EMULATOR E10A-USB H8S(X),SH2(A)EDK7145 - DEV EVALUATION KIT SH7145
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Program Memory Size: -

6.6
6.6.1
The sequence of interrupt operations is explained below. Figure 6.3 is a flowchart of the
operations.
1. The interrupt request sources send interrupt request signals to the interrupt controller.
2. The interrupt controller selects the highest priority interrupt in the interrupt requests sent,
3. The interrupt controller compares the priority level of the selected interrupt request with the
4. When the interrupt controller accepts an interrupt, a low level is output from the IRQOUT pin.
5. The CPU detects the interrupt request sent from the interrupt controller when CPU decodes the
6. SR and PC are saved onto the stack.
7. The priority level of the accepted interrupt is copied to the interrupt mask level bits (I3 to I0) in
8. When the accepted interrupt is sensed by level or is from an on-chip peripheral module, a high
9. The CPU reads the start address of the exception service routine from the exception vector
Note: * Interrupt requests that are designated as edge-detect type are held pending until the
according to the priority levels set in interrupt priority level setting registers A to J (IPRA to
IPRJ). Interrupts that have lower-priority than that of the selected interrupt are ignored.* If
interrupts that have the same priority level or interrupts within a same module occur
simultaneously, the interrupt with the highest priority is selected according to the default
priority order indicated in table 6.2.
interrupt mask bits (I3 to I0) in the CPU’s status register (SR). If the request priority level is
equal to or less than the level set in I3 to I0, the request is ignored. If the request priority level
is higher than the level in bits I3 to I0, the interrupt controller accepts the interrupt and sends
an interrupt request signal to the CPU.
instruction to be executed. Instead of executing the decoded instruction, the CPU starts
interrupt exception processing (figure 6.5).
the status register (SR).
level is output from the IRQOUT pin. When the accepted interrupt is sensed by edge, a high
level is output from the IRQOUT pin at the moment when the CPU starts interrupt exception
processing instead of instruction execution as noted in (5) above. However, if the interrupt
controller accepts an interrupt with a higher priority than the interrupt just to be accepting, the
IRQOUT pin holds low level.
table for the accepted interrupt, jumps to that address, and starts executing the program. This
jump is not a delay branch.
Operation
Interrupt Sequence
interrupt requests are accepted. IRQ interrupts, however, can be cancelled by accessing
Rev.4.00 Mar. 27, 2008 Page 93 of 882
6. Interrupt Controller (INTC)
REJ09B0108-0400