HD64F2145BTE20 Renesas Electronics America, HD64F2145BTE20 Datasheet - Page 482

• Manufacturer Part Number: HD64F2145BTE20
• Description: IC H8S MCU FLASH 256K 100-QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2100r

Specifications of HD64F2145BTE20

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: I²C, IrDA, SCI, X-Bus
• Peripherals: PWM, WDT
• Number Of I /o: 74
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 8K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-TQFP, 100-VQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

Section 16 I
Bit Bit Name
2
0
Rev. 3.00 Mar 21, 2006 page 426 of 788
REJ09B0300-0300
BBSY
SCP
2
C Bus Interface (IIC) (Optional)
Initial Value R/W
0
1
R/W
W
Description
Bus Busy
Start Condition/Stop Condition Prohibit
In master mode:
In slave mode:
[BBSY setting condition]
When the SDA level changes from high to low under the
condition of SCL = high, assuming that the start condition
has been issued.
[BBSY clearing condition]
When the SDA level changes from low to high under the
condition of SCL = high, assuming that the stop condition
has been issued.
To issue a start/stop condition, use the MOV instruction.
The I
before the issue of a start condition. Set MST to 1 and TRS
to 1 before writing 1 in BBSY and 0 in SCP.
The BBSY flag can be read to check whether the I
(SCL, SDA) is busy or free.
The SCP bit is always read as 1. If 0 is written, the data is
not stored.
Writing 0 in BBSY and 0 in SCP: A stop condition is
issued
Writing 1 in BBSY and 0 in SCP: A start condition and a
restart condition are issued
Writing to the BBSY flag is disabled.
2
C bus interface must be set in master transmit mode
2
C bus