R5F61662N50FPV Renesas Electronics America, R5F61662N50FPV Datasheet - Page 867

• Manufacturer Part Number: R5F61662N50FPV
• Description: MCU 24KB FLASH 384K 144-LQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8SX/1600r

Specifications of R5F61662N50FPV

• Core Processor: H8SX
• Core Size: 16/32-Bit
• Speed: 50MHz
• Connectivity: EBI/EMI, I²C, IrDA, SCI, SmartCard, USB
• Peripherals: DMA, LVD, POR, PWM, WDT
• Number Of I /o: 92
• Program Memory Size: 384KB (384K x 8)
• Program Memory Type: FLASH
• Ram Size: 40K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: External
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 144-LQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

22.12
Along with its on-board programming mode, this LSI also has a programmer mode as a further
mode for the writing and erasing of programs and data. In programmer mode, a general-purpose
PROM programmer that supports the device types shown in table 22.14 can be used to write
programs to the on-chip ROM without any limitation.
Table 22.14 Device Types Supported in Programmer Mode
Target Memory MAT
User MAT
User boot MAT
22.13
The boot program initiated in boot mode performs serial communication using the host and on-
chip SCI_4. The serial communication interface specifications are shown below.
The boot program has three states.
1. Bit-rate-adjustment state
2. Inquiry/selection state
In this state, the boot program adjusts the bit rate to achieve serial communication with the
host. Initiating boot mode enables starting of the boot program and entry to the bit-rate-
adjustment state. The program receives the command from the host to adjust the bit rate. After
adjusting the bit rate, the program enters the inquiry/selection state.
In this state, the boot program responds to inquiry commands from the host. The device name,
clock mode, and bit rate are selected. After selection of these settings, the program is made to
enter the programming/erasing state by the command for a transition to the
programming/erasing state. The program transfers the libraries required for erasure to the on-
chip RAM and erases the user MATs and user boot MATs before the transition.
Programmer Mode
Standard Serial Communication Interface Specifications for Boot
Mode
ROM Size
256 Kbytes
16 Kbytes
Rev. 2.00 Sep. 16, 2009 Page 837 of 1036
Device Type
FZTAT256V3A
FZTATUSBT16V3A
Section 22 Flash Memory
REJ09B0414-0200