MPCBL0050N02Q Intel, MPCBL0050N02Q Datasheet - Page 169

• Manufacturer Part Number: MPCBL0050N02Q
• Manufacturer: Intel

Specifications of MPCBL0050N02Q

• Lead Free Status / RoHS Status: Supplier Unconfirmed

Serial Over LAN—MPCBL0050
Note:
9.7.5
9.7.6
9.7.7
Table 70.
September 2007
Order Number: 318146-001
IP and MAC addresses supplied to the IPMC are specified on the command-line as per
Table
subnet. The gateway IP and MAC addresses should be specified with the command to
enable RMCP communication across subnets. If the IP or MAC address options are
missing from the command line, those parameters are not changed on the IPMC.
The IP, MAC, gateway, and gateway MAC parameters are optional. If these settings
have been previously configured and have not changed, it is not necessary to supply
them on the command line every time the scripts is executed.
MAC address for the management interface can be found on the SBC label. It can also
be easily calculated by adding 6 to the last byte of base interface port A MAC address.
Gratuitous ARPs generated by the BMC are enabled and sent every three seconds.
The
SOL Parameters
The SOL payload type is enabled with a privilege level of operator. Neither payload
encryption nor payload authentication is forced. Serial characters are accumulated for
as long as 40 milliseconds or as many as 50 characters. SOL packets are retried every
100 milliseconds, up to seven times. The default SOL baud rate is 9600 bps.
Channel Parameters
Channel 1 is configured as “always available”, meaning that all RMCP traffic to the SBC
LAN adaptor is routed exclusively to the IPMC and not to system software.
For channel 1, User2 is enabled for general IPMI messaging (as opposed to SOL only
messaging). User2 has a privilege level of operator on channel 1.
Command Line Options
The available command-line options for the reference script are given in
SOL configuration reference script command-line options
Option
-m
-H
-h
-n
-g
-V
-j
-I
-l
-i
md5
70. The IP source is set to “static” and the subnet mask is set for a class C
authentication type is enabled for all privilege levels.
“help” - Display usage, version number and a list of options. When this option is specified, all
other options are ignored.
“location” - Specifies which blade to configure. When running on the MPCMM0001, this value
should be one of [“blade1” to “blade14”]. When running on a remote node, this value should be
the IPMB address. When running on the local processor, this option is ignored.
“IP” - Specifies which IP address should be used to configure the blade. The IP address should be
given in the form ###.###.###.### where “###” is a decimal number from 0 to 255.
Specifies the IP address of the subnet’s gateway.
Specifies the MAC address of the subnet’s gateway.
“Gratuitous ARPs” - Turns on gratuitous ARPs. If this switch is not supplied, then generated ARP
responses are enabled instead.
“Version” - Displays the version and quits.
“Interface” - Specifies the interface used to communicate to the IPMC. Must be one of: kcs, lan or
ipmb.
“MAC” - Specifies which MAC address should be used to configure the blade. MAC address is given
in the form of ##:##:##:##:##:##
RMCP-IP - IP address or host name of the shelf manager used to bridge RMCP messages to IPMB.
Intel NetStructure
Meaning
®
MPCBL0050 Single Board Computer
Technical Product Specification
Table
70.
169