MPCBL0050N02Q Intel, MPCBL0050N02Q Datasheet - Page 171

• Manufacturer Part Number: MPCBL0050N02Q
• Manufacturer: Intel

Specifications of MPCBL0050N02Q

• Lead Free Status / RoHS Status: Supplier Unconfirmed

Serial Over LAN—MPCBL0050
Figure 39.
9.8.1.2
Note:
September 2007
Order Number: 318146-001
EFI BIOS configuration of SOL target blade
Operating System Configuration
Configure the operating system baud rate to match the EFI BIOS baud rate:
Hardware flow control is required (hence the
1. When using MontaVista:
2. When using Red Hat RHEL 4 U4:
a. Edit the /etc/lilo.conf file
b. Type
c.
d. Change the append line to read as follows:
e. Once completed, save the lilo.conf file using the
f.
a. Edit the /boot/grub/grub.conf file
b. Type
c.
d. Change the kernel line to read:
e. Type
Set the bootloader baud rate by adding or modifying a line as follows:
On the serial console, type
Change the serial line to read:
Here you are adding
kernel line, if it does not already exist.
kernel /vmlinuz-2.6.XX-XX.ELsmp ro root=LABEL=/ console=ttyS0,
serial --unit=0 --speed=9600 --word=8 --parity=no --stop=1
9600n8 rhgb quiet
vi /etc/lilo.conf
serial=0,9600n8r
append="ip=off console=ttyS0,9600n8r panic=5"
vi /boot/grub/grub.conf
:wq!
to save the changes.
console=ttyS0,9600n8 rhgb quiet
lilo
Intel NetStructure
(see
r
option)
Figure
40).
wq!
®
MPCBL0050 Single Board Computer
command
Technical Product Specification
to the end of the
171