MPCBL0050N02Q Intel, MPCBL0050N02Q Datasheet - Page 66

• Manufacturer Part Number: MPCBL0050N02Q
• Manufacturer: Intel

Specifications of MPCBL0050N02Q

• Lead Free Status / RoHS Status: Supplier Unconfirmed

Table 25.
4.11
Intel NetStructure
Technical Product Specification
66
BIOS PXE
Boot Port *
1701
1800
1801
* BIOS PXE Boot Port xxyy refers to::
Note:
• xx = PCI bus number, for example 02 means bus 2.
• yy = Bits 7-3 is the PCI device number; bits 2-0 is the PCI function number. For example, 00 means device 0, function
0; 01 means device 0, function 1 etc.
For the Ethernet operating system port, this is the default unless the default parameters are changed.
For example, pci=xxx boot parameter.
®
Ethernet port mapping
Identifying MPCBL0050 Ethernet MAC Addresses
On the backing plate of the MPCBL0050, there is a MAC address label to assist a user in
determining the MAC address of each Ethernet port on the SBC. The MAC address may
be needed for PXE boot configuration, configuring Serial Over LAN (SOL) and for OS
configuration.
Figure 26
plate.
the MPCBL0050 faceplate and in the operating system.
The first MAC address (Port A) can be retrieved remotely by using IPMI command.
From that first MAC address (port A), each port increments by 0x01h.
In the IPMI specification (23.2), parameter #5 (MAC address) of the Get LAN
Configuration Parameters Command will be populated automatically with the base
interface MAC address. Alternatively, using ipmitool from the payload processor, the
command is: “ipmitool lan print 1”
Identification
on
MPCBL0050
Faceplate
Port D
Port E
Port F
MPCBL0050 Single Board Computer
Table 25
shows the location of the MAC address label on the MPCBL0050 backing
MAC Address
xxxxxxxxxxx (N+4)
xxxxxxxxxxx (N+3)
xxxxxxxxxxx (N+5)
breaks down the mapping of the Ethernet interfaces to the labeling on
PCI Express Port
MCH Port 4
MCH Port 5
MCH Port 5
PICMG 3.0 Port Definition
Fabric Interface; Port 0, Channel 2
(Ports C and D can be jointly selected to
connect to the backplane or to the RJ45
connectors on the RTM (optional))
Fabric Interface; Port 1, Channel 1
(Ports E and F can be jointly selected to
connect to backplane (default setting)
front panel RJ45 or RTM RJ45.)
Fabric Interface; Port 1, Channel 2
(Ports E and F can be jointly selected to
connect to backplane (default setting)
front panel RJ45 or RTM RJ45.)
MPCBL0050—Operating the Unit
Order Number: 318146-001
September 2007