MPCBL0050N02Q Intel, MPCBL0050N02Q Datasheet - Page 209

• Manufacturer Part Number: MPCBL0050N02Q
• Manufacturer: Intel

Specifications of MPCBL0050N02Q

• Lead Free Status / RoHS Status: Supplier Unconfirmed

Firmware Update Utilities—MPCBL0050
10.6.12.1
10.6.12.2
September 2007
Order Number: 318146-001
Incremental FRU Update via KCS
To perform an incremental FRU update, use the supplied FRU file from the release
package for your target IPMC along with the supplied /usr/share/doc/sbcutils/
master.cfg file provided with the SBC utilities package. Staged FRU updates are not
supported, therefore it is not necessary to specify direct mode (-M direct).
Here is an example of a full FRU update:
To update the RTM FRU over the KCS interface on the MPCBL0050 SBC, execute the
following command:
The output from this command should be similar to the following:
Beginning update of the FRU.
Writing FRU - Addr(0x20) ID(0) Bus(255)
Writing FRU Board Info Area
Writing FRU Product Info Area
Writing FRU Multi Record Area
Verifying contents of FRU
The FRU has been successfully updated.
Program exiting!
Incremental FRU Update via RMCP Bridging
To perform an incremental FRU update, use the supplied FRU file from the release
package for your target IPMC along with the supplied /usr/share/doc/sbcutils/
master.cfg file provided with the sbc utilities package. Staged FRU updates are not
supported, therefore it is not necessary to specify direct mode (-M direct).
For RMCP bridging to work correctly, the Shelf Manager must be connected to the
network so that it can transmit TCP/IP traffic to and from the client. The interface
option must also be set to lan for RMCP bridging.
When using the sbcupdate utility over an RMCP bridge with the Intel NetStructure
MPCMM0001/0002 Chassis Management Module:
When using the sbcupdate utility over an RMCP bridge with a 3rd party Shelf Manager,
it is essential that communication between the target IPMC and a remote network node
via a shelf manager can be established. Refer to
privileges for RMCP bridging” on page 190
commands that must be forwarded to IPMB by the Shelf Manager.
The command to update the IPMC FRU on the MPCBL0050 has the following syntax:
• The Product ID in the input file does not match the product ID of the system.
• The FRU version information is missing either from the system or from the input
• Check for a CMM firmware version of 6.1.1.x or higher.
• Transfer the /usr/share/doc/sbcutils/cmdPrivilege.ini file to both the active and
file.
standby CMMs. Place cmdPrivelege.ini in the /etc/ directory on the CMMs. Then,
restart the RMCP servers. More details on this can be found in
“Configuring the Intel NetStructure
# sbcupdate -I kcs /usr/share/doc/sbcutils/master.cfg MPCBL0050_NNN.fru
# sbcupdate -I kcs -t rtm /usr/share/doc/sbcutils/master.cfg MPRTM0050_NNN.fru
®
MPCMM0001/0002 CMM” on page
for more information on the required RMCP
Intel NetStructure
Table 74, “Required IPMI command
®
MPCBL0050 Single Board Computer
Technical Product Specification
Section 10.5.2,
191.
®
209