MPCBL0050N02Q Intel, MPCBL0050N02Q Datasheet - Page 201

• Manufacturer Part Number: MPCBL0050N02Q
• Manufacturer: Intel

Specifications of MPCBL0050N02Q

• Lead Free Status / RoHS Status: Supplier Unconfirmed

Firmware Update Utilities—MPCBL0050
10.6.7
Note:
10.6.7.1
10.6.7.2
September 2007
Order Number: 318146-001
Direct Firmware Update
The user must not initiate a direct firmware update while a direct firmware update is in
progress. Doing so results in the sbcupdate utility exiting because of write/verify
failures. If this does happen, exit all invocations of sbcupdate, then the sbcupdate
utility can be run again to update the firmware.
Direct Firmware Update Using the KCS Interface
To perform a direct firmware update over the KCS interface, you must be logged into
the target SBC as root. Note that the KCS is the default interface if the -I option is
omitted, so the command line can be abbreviated.
The syntax of the command using the short form for the options is:
The syntax of the command using the long form for the options is:
Entering Direct Firmware Update mode.
Entered Direct Firmware Update mode.
Erasing the current firmware area.
The firmware area has been erased.
Updating firmware.
0% completed
10% completed
20% completed
30% completed
40% completed
50% completed
60% completed
70% completed
80% completed
90% completed
100% completed
Exiting direct firmware update mode.
Firmware successfully updated.
Program exiting!
Direct Firmware Update to RTM via KCS
To perform a direct firmware update to an RTM, you must specify the target, -t option,
to be the RTM. By omitting the -I option, the interface defaults to KCS.
For target information, refer to
arguments” on page
The following is an example of an RTM direct firmware update with the -I option
omitted:
# sbcupdate -I kcs -M direct <path to firmware image/filename>
# sbcupdate --interface kcs --mode direct
The output from this command should be similar to the following:
# sbcupdate -M direct -t rtm MPRTM0050_NNNNNN.hex
<path to firmware image/filename>
198.
Table 76, “Common command line options and
Intel NetStructure
®
MPCBL0050 Single Board Computer
Technical Product Specification
201