MPCBL0050N02Q Intel, MPCBL0050N02Q Datasheet - Page 212

• Manufacturer Part Number: MPCBL0050N02Q
• Manufacturer: Intel

Specifications of MPCBL0050N02Q

• Lead Free Status / RoHS Status: Supplier Unconfirmed

10.6.15
10.6.15.1
Note:
Note:
10.6.15.2
Intel NetStructure
Technical Product Specification
212
®
Beginning update of the FRU.
Writing FRU - Addr(0x20) ID(0) Bus(255)
Writing FRU Internal Use Area
Writing FRU Board Info Area
Writing FRU Product Info Area
Writing FRU Multi Record Area
Verifying contents of FRU
The FRU has been successfully updated.
Program exiting!
Writing SDR Data
SDR Update via KCS
To perform an SDR update via KCS, use the supplied SDR file from the release package
for your target IPMC. Staged SDR updates are not supported, therefore it is not
necessary to specify direct mode (-M direct).
If no interface is specified, KCS is assumed.
The output of this command should be similar to the following:
Beginning update of the SDRs.
Upgrading the SDR from version unkown to version 0.1.
The SDRs have been successfully updated.
The proxied target management controller is being reset.
The porxied target management controller has been reset.
The target management controller is being reset.
sbcupdate (W606) Please ignore any select timeout warnings. They are issued by
the Linux driver due to target reset and may be ignored.
IPMI message handler: BMC returned incorrect response. Expected netfn 7 cmd 2.
got netfn 7 cmd 33
The target management controller has been reset.
Program exiting.
The “IPMI message handler: BMC returned incorrect response.” error message is to be
expected and may be ignored. This is a timeout error in response to warning (W606) as
seen in the output above. This exact error message may not appear and it may not
always be the same error message.
When performing an SDR update, in certain circumstances it may be necessary to
invoke the --force-sdr-update option. The following are instances of when to invoke this
option:
An example of the use of the --force-sdr-update option is:
RTM SDR Update via KCS
To perform an RTM SDR update, you must specify the target (-t option) to be the RTM.
You will use the supplied SDR file from the release package for your target RTM.
The following is an example of updating an RTM SDR:
• Downgrading an SDR version.
• The SDR version information is missing either from the system or from the input
• The target has a pending staged firmware update or with RTM/AMC targets, the
MPCBL0050 Single Board Computer
file.
carrier board has a pending update.
# sbcupdate -I kcs --force-sdr-update MPCBL0050_NNN.sdr
MPCBL0050—Firmware Update Utilities
Order Number: 318146-001
September 2007