MPCBL0050N02Q Intel, MPCBL0050N02Q Datasheet - Page 188

• Manufacturer Part Number: MPCBL0050N02Q
• Manufacturer: Intel

Specifications of MPCBL0050N02Q

• Lead Free Status / RoHS Status: Supplier Unconfirmed

Note:
10.4
10.4.1
Note:
10.4.2
Intel NetStructure
Technical Product Specification
188
®
The board does not boot up until the front panel reset button is pressed and released.
SBC Utilities Installation Procedure
The SBC utilities and the supporting libraries are packaged together and released as a
single RPM package manager archive (RPM). This rpm file is included as part of the
MPCBL0050 IPMC Update Utilities package. The filename is “MPCBL0050-sbcutils-
w.x.y-z.i386-mv40.rpm”, where MPCBL0050 refers to the Single Board Computer. This
utility is specifically created for this board only.
Contents of SBC Utilities RPM Package
The SBC utilities rpm includes the following:
The SOL client for the SBC is ipmitool. This tool is not part of the SBC utilities RPM
package, but is discussed in this chapter.
Remove Existing Packages
Before installing the RPM on a host system (Single Board Computer), verify that a
different version of the sbcutils RPM is not currently installed.
15. Reinsert the blade into the chassis.
16. If there is a IPMC operational code in the rollback area, this will be copied
17. If the board doesn’t boot, there was not valid IPMC operational code image in the
18. Once the board boots, the IPMC operational code must be updated using the direct
19. After the direct IPMC firmware update, the board payload power will be cycled and
• x refers to the software generation number.
• y refers to the Interim Product Release number. This is typically changed when the
• z refers to the build number of the software.
• sbcupdate - a binary tool that is used to perform an IPMC firmware upgrade. It also
• reference_cfg - a reference configuration script that contains all the necessary IPMI
• reference_funcs - a support file that contains functions used by the reference_cfg
MPCBL0050 Single Board Computer
automatically to the IPMC and the board will boot. Once the board boots, then
update the IPMC firmware using the staged firmware update mode. Refer to
Section 10.6.8, “Staged Firmware Update” on page
this procedure do not need to be followed.
rollback area. If this happens, press and release the front panel reset button. This
will force the board payload power to turn on. Then follow the remaining steps in
this section.
firmware update mode. Staged firmware update mode does not work the first time
after updating the boot block. Refer to
page
the board will automatically reboot. This reboot only occurs after the boot block is
updated followed by an IPMC operational code update. All subsequent IPMC
firmware updates do not impact payload power.
release includes bug fixes.
updates FRU and SDR information on the SBC and the RTM.
commands to enable and configure the SBC for SOL functionality on the
MPCBL0050SBC.
script.
201.
Section 10.6.7, “Direct Firmware Update” on
MPCBL0050—Firmware Update Utilities
203. The rest of the steps in
Order Number: 318146-001
September 2007