MPCBL0050N02Q Intel, MPCBL0050N02Q Datasheet - Page 220

• Manufacturer Part Number: MPCBL0050N02Q
• Manufacturer: Intel

Specifications of MPCBL0050N02Q

• Lead Free Status / RoHS Status: Supplier Unconfirmed

Table 77.
Intel NetStructure
Technical Product Specification
220
®
Informational messages (Sheet 2 of 3)
New staged firmware image successfully
uploaded.
Forced firmware update in progress,
ignoring product and manufacturer IDs.
Registering the staged firmware update in
flash.
Staged firmware update successfully
registered in flash.
Staged Firmware Update complete!
Entering Direct Firmware Update mode.
Entered Direct Firmware Update mode.
Updating firmware.
Firmware successfully updated.
Exiting direct firmware update mode.
Program exiting!
Mismatch at offset %1 (length %2 bytes).
Got: %1
%1%% completed
The %1 target management controller is
being reset.
The target management controller has
been reset
MPCBL0050 Single Board Computer
Expected: %2
Message
This informational message is displayed once the image has
finished being written to flash memory. This does not imply the
update is complete.
This informational message is displayed when the force id
command-line option is included in the update. This overrides
comparisons between product and manufacturer IDs between the
supplied HEX file from Intel and what is on the SBC. This would
be used in the event the firmware is corrupt and is reporting false
information about the SBC; use this only when directed.
This informational message is displayed at the conclusion of the
staged update. It indicates that the staged image was
successfully written and verified. A bit is set in flash memory
telling the IPMC to write the new staged image to the operational
area on the next IPMC reset. This operation may take a few
seconds, depending on system activity.
This informational message is displayed when the registration of
the valid staging image has been completed.
This informational message is displayed when all staged update
operations have completed successfully. This indicates the update
has been completed.
This informational message is displayed when a direct firmware
update is being initiated. This indicates the operational code in
the IPMC is being halted, and all commands will be serviced by
the boot block. This operation may take a few seconds, depending
on the number of outstanding transactions being processed by
the IPMC.
This informational message is displayed after the transition from
operational firmware to boot block has been completed. This is
only displayed once a GetDeviceID shows the lowest bit of byte 4
on, per the IPMI spec (Is Device Busy).
This informational message is displayed before the writing of the
firmware is initiated.
This informational message is displayed after the new firmware
has been written and verified.
This informational message is displayed when the transition from
the boot block back to the new operational code is initiated. This
message implies that the IPMC is being reset.
This informational message is displayed when the utility has
completed all operations and is completing execution.
This informational message is displayed if the write verification
during a direct firmware update finds a mismatch. %1 is replaced
with the byte offset that the difference was located at and %2 is
replaced with the number of bytes found to be different.
This informational message is displayed if the write verification
during a direct firmware update finds a mismatch. %1 is replaced
with the data byte read from flash memory, and %2 is replaced
with the data byte that should have been in flash memory.
This informational message is displayed during a direct firmware
update for every 10% of the firmware image written. %1 is
replaced with the percentage completed. It ranges from 0% to
100%.
This informational message is displayed after the utility is about
to sent a cold reset command to the target MMC.
This informational message is displayed after the utility has sent
a cold reset command to the target MMC and no error completion
codes have been received.
MPCBL0050—Firmware Update Utilities
Description
Order Number: 318146-001
September 2007